Taurus 997150 Manual De Instrucciones página 4

gasoline or oil based products. Rinse thoroughly before
starting.
•Keep ventilation openings in the appliance enclosure,
or in the built-in structure, clear of obstruction. Do not
use mechanical devices or other means to accelerate
the defrosting process, other than those recommended
by the manufacturer.
•If the icemaker is reused after a long time, the water
pump may not pump sufficient water due to an air
block, the deficient water indicator turns on in this
case.
•To correct this press the ON/OFF button again, then
the icemaker will work normally.
•To ensure the cleanliness of the ice cubes, water in
the water reservoir should be replaced every 24 hours.
•If the compressor stops for any reason such as water
shortage, too much Ice, power off, etc... Do not start
the system right away, wait 3 minutes, and then re-
start the ice maker.
•Always use fresh water before starting ice produc-
tion either at initial installation or after a long shut-off
period.
5. Anomalies and repair
5.1. Take the appliance to an authorised support centre
if product is damaged or other problems arise.
5.2. If the connection to the mains has been damaged,
it must be replaced and you should proceed as you
would in the case of damage.
6. Troubleshooting
6.1. Please note, if a power failure occurs due to
disconnection of the power cord, or the off power
button has been pushed off during an ice making cycle,
small ice chips may form and lodge in the automatic
shovel causing it to jam. If this occurs, the ice chips
may be removed by disconnecting the power cord and
gently pushing the shovel to the rear of the cabinet and
removing the ice chips, then restarting.
6.2. Please restart the ice maker by pressing "OFF"
and then "ON". If the ice shovel does not push the ice
into the ice collector after the formed ice drops from
the evaporator finger while at the same time the M light
is on, check to see if the water tray is horizontal or
balanced. If not then adjust by pressing the ice shovel
lightly with your finger. Then restart the ice maker.
WARNING
If the power cord is damaged; it must be replaced
by the manufacturer, its service agent or a similarly
997150_IM.indd 4
qualified person in order to avoid a hazard.
Fill with potable water only.
It is normal for the compressor and condenser surface
to reach temperatures between 70°C and 90°C during
operation and surrounding areas may be very hot.
Due to fast freezing, ice cubes may appear "Cloudy".
This is air trapped in the water and will not affect
quality or taste of ice.
This appliance is not intended for use by
persons (including children) with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge unless they have
been given supervision or instruction concerning use of
the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.
Do not immerse in water.
Correct Disposal of this product - This
indicates that this product should not be disposed with
other household wastes. To prevent possible harm to
the environment or human health from uncontrolled
waste disposal,recycle it responsibly to promote the
sustainable reuse of material resources.
marking
2018/01/15 11:14:02 AM