Maintenance And Storage - Lanaform Stim Fit Manual De Instrucciones

3) Operation
• Once the electrodes are in position on the muscles which you want to work (see diagram 3), switch on your device
with the ON/OFF button (diagram 1, point 2).
• The device is running and tapping set as the default mode (diagram 2, point 2a). It is set to the lowest intensity and
programmed to run for 20 minutes.
• To change mode, press button M several times until the massage mode you want appears
(see diagram 1, point 5).
• To increase the intensity, use buttons + and - to adjust it (see diagram 1, point 6 and diagram 2, point 3)
• Finally, to adjust the time, press button T (diagram 1, point 8) and diagram 2, point 1) and choose a time between
10 and 60 minutes.
• Notes:
• You can stop the treatment at any time by pressing the pause button. You can also change the massage mode by
pressing button M again.
• We recommend starting at a low intensity the first time you use the device, then gradually increasing it. Once you
are used to the stimulation, you can use more powerful intensities of stimulation, but always within the limit of
what you are able to tolerate and without injuring yourself, so as to stimulate as many fibres as possible.
• Treatment time: The length of use in one position is generally 20 minutes per session and once or twice a day. The
time can also be extended or reduced depending on the user's needs. The device will stop automatically when
the time set has expired. If you want to continue with the treatment, switch off the device for a few seconds, then
switch it on again.
• The screen can be blocked during treatment. To do this, press the central button for 3 seconds. Press again for 3
seconds to unblock the screen.
4) Charging
You can charge your device using the USB cable or the mains power supply. To do this, just insert the USB cable in
the port provided for this purpose (diagram 1, points 12 and 13). The device is recharged when the battery charge
indicator is full (diagram 2, point 4).
Note: Recharge your device at least once every three months if it is not used regularly.

MAINTENANCE AND STORAGE

Cleaning:
1. Cleaning the main unit: Wipe the unit with a soft, dry cloth.
2. Cleaning the electrodes: in order to keep your electrodes clean for longer, apply a few drops of water before and after
use. Re-attach the electrodes to the plastic holder (diagram 1, point 9) and wind the cables around the groove on the
holder.
Storage:
Keep out of reach of children.
Do not store the main unit anywhere that is exposed to high temperatures, high humidity or direct sunlight. Put it back
into its box after use and store in a dry place.
EN
Stim Fit
5