Cleaning The Device - Lanaform Stim Mass Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
tissue. This applies to the surface and depth of tissue
volume. Likewise, the greater the distance between
the electrodes, the more the tissue stimulation
strength decreases. This means that if you opt
for a wide distance between the electrodes, the
volume will be greater but the stimulation will
be less powerful. To increase stimulation, you
will have to increase the intensity of the impulses.
The following guideline applies for choosing the
distance between the electrodes:
·
The most appropriate distance: approx. 5 to 15 cm
·
Below 5 cm, the primary surface structures are
strongly stimulated.
·
Above 15 cm, the deep structures and extending
onto wider surfaces are very weakly stimulated.
It is not advisable to use two electrodes
on opposite sides of the body (example:
first cable's electrode on the left arm and
second cable's electrode on the right arm).
For optimum and safe use, it is advisable
to spread out and connect the electrodes
as shown in the diagram 2, 3.
Never apply the electrodes on the head
Never move the electrodes when the device is
operating. Switch off the device then remove
the electrodes only to place them somewhere
else. If not, you may feel an impact.
OPERATION
Once the electrodes are positioned on the area
you want to massage and relax (see 2), connect
the power supply cable ( 1
unit ( 1
ON/OFF switch ( 1
The device is working and programmed by default
on the "Suction" massage mode for 15 minutes
at intensity 0. ( 1
To change mode, press the mode selection button
several times (
the desired massage mode.
To increase the intensity, use the
buttons to adjust it ( 1
Lastly to set the massage time, press the timer
button (
between 5 and 15 minutes.
Stim Mass - LA100206 - 001 - 2017 - Notice - K - 1.0.indd 7
8) to the main
2) and turn on your device using the
1).
11, 13, 14)
and 1
13) until you reach
and
14)
and 1
11) and choose a time
EN
FR NL DE ES IT PL CS SK SL HR BG SV AR
COMMENTS
You can stop the session at any time by switching
the device off. You can also change the massage
mode by pressing the massage mode selection
button again.
When you first you use it, we recommend you
start with a low intensity and then progressively
increase it. Once you are accustomed to stimu-
lation, you can use more powerful stimulation
intensities, always at the limit you can tolerate
and without harming yourself, so as to stimulate
as many fibres as possible.
The length of use for one position is normally
15 minutes per session, once or twice a day. You
can also extend or shorten the operating time
depending on your requirements. The device
will stop automatically when the time set has
run out. If you want to continue the treatment,
switch the device off for a few seconds, then
switch it on again.
MAINTENANCE AND STORAGE
SELF-ADHESIVE ELECTRODES
So the electrodes keep their adherence for as
long as possible, carefully clean them with a lint
free damp cloth.
Re-stick the electrodes onto the plastic holder
( 1
6) and wind the cable round the groove
on the holder.

CLEANING THE DEVICE

Before any cleaning, remove the batteries from
the device,
After each use, clean the device with a slightly
damp soft cloth. If it is very dirty, you can use a
cloth dampened with a mild detergent solution.
Ensure that water does not get into the device. If
this should occur, do not re-use the device until
it is totally dry.
For cleaning, do not use chemical or abrasive
cleaning products.
STORAGE
If you do not think you will use it for some time,
remove the batteries from the device Leaking
batteries can damage the device.
Stim Mass EN Instruction manual
7
/ 80
12/07/2017 12:16:39
Tabla de contenido

Solución de problemas

loading

Tabla de contenido