Installation Requirements; Location Requirements; Electrical Requirements; Installation Instructions - Haier HRQ16N3 Manual Del Usuario

INSTALLATION REQUIREMENTS

LOCATION REQUIREMENTS

WARNING
Explosion Hazard
Keep ammable materials and vapors, such as gasoline,
away from appliance.
Failure to do so can result in death, explosion or re.
IMPORTANT: This refrigerator is designed for indoor, household use
only.
NOTE: To ensure proper ventilation for your refrigerator, allow for
2" (5.08 cm) of space behind the refrigerator. When installing your
refrigerator next to a fixed wall, leave 4" (10 cm) minimum space to
allow the door to swing open.
This refrigerator is intended for use in a location where the
temperature ranges from a minimum of 55°F (13°C) to a maximum
of 110°F (43°C). The preferred room temperature range for
optimum performance, which reduces electricity usage and
provides superior cooling, is between 60°F (15°C) and 90°F (32°C). It
is recommended that you do not install the refrigerator near a heat
source, such as an oven or radiator.

INSTALLATION INSTRUCTIONS

UNPACK THE REFRIGERATOR

WARNING
Fire or Explosion Hazard
Do not puncture refrigerant tubing.
Follow handling instructions carefully.
Flammable refrigerant used.
Failure to do so can result in death, explosion or re.
IMPORTANT: Handle with care when moving refrigerator to avoid
either damaging the refrigerant tubing or increasing the risk of a
leak.
4

ELECTRICAL REQUIREMENTS

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the power
cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, re or
electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical connection.
Recommended Grounding Method
A 115 volt, 60 Hz, AC only 15- or 20-amp fused, grounded electrical
supply is required. It is recommended that a separate circuit serving
only your refrigerator be provided. Use an outlet that cannot be
turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation or cleaning,
disconnect the refrigerator from the electrical source. When you
are finished, reconnect the refrigerator to the electrical source and
reset the temperature controls to the desired setting.
WARNING
Excessive Weight Hazard
Use two or more people to move and install refrigerator.
Failure to do so can result in back or other injury.
REMOVE THE PACKAGING
•
Remove tape and glue residue from surfaces before turning on
the refrigerator. Rub a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm water and dry.
•
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see "Refrigerator Safety."
•
Dispose of/recycle all packaging materials.