Operation; Maintenance; Daily, By A Trained Operator; Every 25,000 Loaves And/Or At Least Once A Year, By An Approved Agent - JAC CHUTE Traducción Del Manual De Uso Original

7

OPERATION

Braked castors must be locked while the machine is in operation (fig.1, n°10).
Switch on the power to the machine at the start of the day using the emergency stop
(fig.4, n°24).
Operating procedure (fig.5,6)
A. Set the ramp guides and set the outfeed table guide or guides using the thumbscrews to
adjust them to the length of the loaves to be sliced.
B. Set the loaf holder using the thumbscrew located on the right-hand side of the machine to
adjust it to the height of the loaves to be sliced.
C. Load the loaves onto the loading ramp.
D. Press the green button to start the machine; gravity and the weight of the loaves loaded onto
the ramp will push the loaves into the blades thus causing them to be cut.
E. When the last loaf goes into the blades, operate the last loaf pusher lever to push it out of the
blades and thus collect it sliced.
F. Collect the loaves on the outfeed table.
OPTIONAL: Press the white button to operate the blower (fig.7).
At the end of the day, press the red emergency stop button (fig.4, n°24) to switch the power off to
the machine.
Tip: Have a qualified individual check blade tension after the first few days of operation.
Capacity: Number of loaves sliced per hour: 500 (depending on the type of bread).
Loaf size (L x H) (cm): min.: 22 x 6 - max.: 44 x 14
8

MAINTENANCE

8.1

Daily, by a trained operator.

A. Check whether you need to empty the crumb tray.
B. Clean the table and the ramp using a brush.
C. Use a dry cloth to clean the inside.
D. Use a damp cloth to clean the outside.
8.2

Every 25,000 loaves and/or at least once a year, by an approved agent.

A. Remove the plug from the socket (fig.1, n°10).
B. Check the condition of the cutting blades.
C. If you notice a deterioration in cutting quality, the cutting blades must be replaced (JAC part
number: 6100012 in the JAC Spare Parts catalogue).
D. If the blades need to be replaced, do so in accordance with the blade replacement procedure
(§8.3).
E. NB: Do not overtighten the blades, as this risks distorting the frames.
F. Sweep and vacuum the inside of the machine.
G. Check bearing condition, then lubricate them.
H. Lubricate the actuator joints.
11
English