Idiomas disponibles
Idiomas disponibles
Thank you for choosing our product! In order to take the most of your welder, please read the following
instructions carefully:
These welding are, Inverter, portable welder, for covered electrode and TIG Lift in DC. It allows welding with rutiles,
basic, stainless steel and cast iron electrodes. (only GYSMI E200 CEL). . In TIG, it allows to weld most of metals
except aluminium and alloys. It is protected for a use on electric generators (230V /+- 15%).
• These machine are delivered with a 230V socket /16A plug type EEC7/7. Le GYSMI E200 PFC be plugged on a 230
V (50-60Hz) with earth. Le GYSMI E200CEL 200 integrates a « Flexible Voltage » system. It has to be on a power
suply variable between 110V and 240V (50 – 60 Hz)
on the machine, for maximal using conditions. Check that the power supply and its protection (fuse and/or circuit-
breaker) is compatible with the necessary current during use. In some countries, the change of plug can be
necessary to allow a use at maximal conditions. The welder must be installed so that the main plug is accessible.
•
The start-up is done by pressing
The device turns into protection mode if the supply voltage is over 265V for the single-phase products
(the sreen displays
range.
• These are A-class devices. They are designed to be used in an industrial or professional environment. In a
different environment, it can be difficult to ensure electromagnetic compatibility, due to conducted
disturbances as well as radiation.
•
The GYSMI E200PFC features primary regulation, it is recommended to use the cables supplied with the unit.
• Leave the machine connected to the supply after welding in order to let it cool down.
• Thermal protection : thermal protection indicator turns on and the cooling time is about 2 to 5 min
according to external temperature.
• Your machine is equipped with 3 specific functions to Inverters :
(adjustable mode, see below) increases the current at the beginning of the welding.
(adjustable mode only on the GYSMI 195-196FV-252-253/MASTER 200 models) increases
the current in order to avoid the sticking when electrode enters in melted metal.
allows you to easily withdraw your electrode without damaging it in case of sticking.
- Select the MMA position
- Adjust the wished current (display
low Hot Start : for thin metal sheets
high Hot Start for metals that are difficult to weld (dirty or oxidized parts)
To adjust the Hot Start and Arc Force, go through the following steps.
Press the selector
Set the required percentage ( display
Valid the required figure by pressing the selector button
Set the required percentage (display
Valid the required figure by pressing the selector button .
(
)
). Normal operation will resume
with the selector.
) using the key
Hot Start
Arc Force
Automatic
during 3 seconds.
earth.
The absorbed effective current (I1eff) is shown
when the voltage has returned to its nominal
.
0
90%
0
90%
) using keys
) using keys
.
7
