Installation - Warn 91810 Manual Del Usuario

Always use extreme caution when drilling on any vehicle. Make sure that all fuel lines, brake lines, electrical wires, and other objects are not
WARNING
punctured or damaged when/if drilling on the vehicle. Thoroughly inspect the area to be drilled (on both sides of material) prior to drilling, and relocate any
objects that may be damaged. Failure to inspect the area to be drilled may result in vehicle damage, electrical shock, fire or personal injury.
Always wear safety glasses when installing this kit. A drilling operation will cause flying metal chips. Flying chips can cause eye injury.
WARNING
Always take time to fully read and understand the installation and Operations Guide included with this product.
WARNING
1.

INSTALLATION

Figure 1: Locate skid plate and remove if possible.
3. INSTALLATION
(4) U-bolts
Place two u-bolts near the front end of frame (near or between front a-arms) and two u-bolts in the rear of frame (near or between foot
pegs). The front and rear sets of u-bolts should be no less than 10 inches and no more than 25 inches apart.
Figure 3: Correct Placement (u-bolts parallel and between 10" - 25" apart).
©2013 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
I N S T A L L A T I O N I N S T R U C T I O N S
Factory Skid Plate
Front of vehicle
2. INSTALLATION
Figure 2: Determine proper u-bolt position.
Front of vehicle
Figure 4: Incorrect Placement - (u-bolts not parallel and over 25" apart)
4
91853A1