Input, Output And Control Section - dBTechnologies VIO W10 Manual Del Usuario

English

INPUT, OUTPUT AND CONTROL SECTION

1. BALANCED AUDIO INPUT
Balanced XLR connector allowing the connection
of a line or microphone input. The input
sensitivity must be set with the relevant switch,
described in point 3.
2. INPUT ATTENUATION
Allows the input attenuation to be adjusted (and,
in particular, it indicates the 0 dB, -6 dB and -10 dB
references).
3. AUDIO INPUT SENSITIVITY
Two-position switch: set to "Line" for line input
signals (e.g. from a mixer) or "Mic" (for signals
from a microphone source).
4. OUTPUT LINK
Balanced XLR output intended to send the audio
signal to an additional amplified monitor.
5. COVERAGE PRESET
Rotary switch allowing to set a monitor coverage
preset.
Depending on stage requirements, 4 positions enable
the following presets (refer to the figures on the
screen print for immediate understanding):
- STANDARD (standard sound reinforcement)
- NARROW (the narrowest possible pattern)
- WIDE (the widest possible pattern)
- FAR (the pattern that projects the sound as far away as possible)
An HPF filter with 120 Hz cut-off frequency can also be applied to the NARROW, WIDE and FAR presets.
6. STATUS LED Main
The LEDs show monitor status indications at a glance, according to the logic summarised in the table below:
VIO W10 Code 420120291 REV.1.0
23