Camera Installation - Manfrotto MVG220 Instrucción

3

Camera Installation

Step 1: Mount quick release plate ①
fixed plate ②, lock it. Loosen the ARCA
quick release plate safety lock ③, take
out ARCA quick release plate ④.
Step 3: Insert ARCA quick release plate
①
directly into quick release plate , tighten
the safety lock ③ for ARCA quick release
plate.
⚠
Make sure the battery and memory
card are installed before camera
installation.
Step 2: Mount camera on ARCA
on
quick release plate ④ .
Step 4: Install lens holder ⑤
support lens, and tighten the thumb
screw.
5 5
4
Gimbal Balancing
TIPS
1) Before balancing the gimbal, please lock the gimbal at the balanced lock status.
2) Lens cover should be removed from the camera and the memory card needs to
be inserted to the camera to complete all the connections to ensure that the camera
is ready for shooting.
3) When balancing the gimbal, make sure the camera and gimbal are all powered
off.
4) If it is needed to add accessories after the balance is completed, gimbal needs to
be re-balanced again.
4.1 Balance Tilt Axis
(1) a. Unlock the tilt axis position lock ①, turn the camera lens upwards, and check the
gravity center of camera.
b. Loosen the sliding arm lock screw ②, slide the sliding arm
c. Tighten the sliding arm lock screw ②, when the camera lens keeps upwards that
means balanced.
to
5
5
7
GB
③
to balance the camera.