WELDY energy HT1600 Manual De Operación página 4

Applications
This hot-air tool is intended for all of the hot-air applications listed here, subject to compliance with safety regulations and the utilization of original Leister accessories:
• Welding of all thermoplastic synthetic materials • Shrinkage & forming of thermoplastic synthetic materials
• Welding of foils & plastic sheeting
Deutsch
Warning
English
Français DANGER! Danger when opening up the tool, as live components and
Español connections are exposed. Therefore, before opening it, unplug the tool
Português to ensure disconnection from the mains. Before putting into operation,
check power supply cord and connector as well as extension cable for
Italiano
electrical and mechanical damage.
Nederland
Dansk
Incorrect use of the Hot Air Tool (eg. overheating of the material) can
Svenska
present a fire and explosion hazard, especially near combus t ible
Norsk
materials and explosive gases.
Suomi
Do not touch the heating element housing and air nozzle when
Eλληνικά
they are hot as they can cause burns. Let the tool cool down. Do
Türkçe
not point the hot air flow in the direction of people or animals.
Polski
Attention
Magyar
Česky The voltage rating stated on the tool must correspond to the mains
Slovensky voltage.
Românã
For personal protection on building sites we strongly recommend
Slovensko
the tool be connected to a RCCB (Residual Current Circuit Breaker).
Български
The tool must be operated under supervision. Heat can ignite flam-
Eesti
mable materials which are not in view. The machine may only be used
Lietuviu
by qualified specialists or under their supervision. Children are not
Latviešu
authorized to use this machine.
Русский
日本語
Protect tool from damp and wet.
中文
Repairs should only be carried out by authorized service points.
‫ﻋﺮﺑﻲ‬
Restricted to use with original Weldy accessories and spare parts.
ภาษาไทย
4
Original Operating Manual
• Activation/detaching of solvent-free adhesives & hot melt adhesives • Soldering of copper pipes, solder connectors & metal foils
• Drying of watery-moist surfaces
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distri-
butor/seller shall apply. In case of guarantee or warranty claims any manu-
facturing or workmanship defects will either be repaired or replaced by the
distributor at its discretion. Warranty or guarantee rights have to be verified by
an invoice or a delivery document. Heating elements shall be excluded from
warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandato-
ry provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and
tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered
or changed by the purchaser.
Conformity
Weldy AG, Galileo-Strasse 10, 6056 Kaegiswil/Switzerland, confirms that
this product, in the version as brought into circulation through us, fulfils the
requirements of the following EC directives.
Directives: 2006/42,
2004/108 (until 19.04.2016), 2014/30 (starting 20.04.2016),
2006/95 (until 19.04.2016), 2014/35 (starting 20.04.2016),
2011/65
Harmonized EN 12100, EN 55014-1, EN 55014-2, EN 61000-6-2,
Standards: EN 61000-3-2, EN 61000-3-3, EN 62233, EN 60335-2-45,
EN 50581
Kaegiswil, 20.04.2015
Bruno von Wyl, CTO Peter Kathriner, GM