Setting The Switches - Sony IFB-12A Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
5 DIP switch
Set the position of the DIP switch according to the input signal.
(Refer to "Setting the DIP switch".)
Mounting the IFB-12A
Note
Mounting or removal of signal interface boards must be performed by
qualified personnel only.
This section is for qualified service personnel only.
1
1 Loosen the screws completely and remove the panel.
2 Push in the IFB-12A along the rail.
3 Tighten the screws.
When removing the IFB-12A, loosen the screws completely and pull it
out.

Setting the Switches

Note
Be sure not to change the setting of the SW6, 7 and JP-3, 4, 5
connectors, as this may damage the equipment connected to this unit.
2
IFB-12A.3-858-497-04 (1)
3
11
Tabla de contenido
loading

Tabla de contenido