Tabla de contenido
Trigger Sensor Adjustment
Refer to Troubleshooting for trigger sensor adjust-
ment, and Operation Manual 309892.
Distance Sensor Adjustment
Gear Alignment
FLUID INJECTION
1.
HAZARD; page 3.
2. Relieve pressure; page 8.
3. Fig. 3. Remove dust cap (77) from wheel.
Remove nut (76).
4. Remove wheel (74) from LineLazer.
5. Align gear (59) with sensor.
a. Pull gear out from wheel with gear puller.
76
77
I
nside of tire
Fig. 3
16
309896
60
Frame
74
Axle
b. Push gear in toward wheel with mallet.
6. Install wheel (74) on LineLazer.
7. Install nut (76) until tight, then back off 1/4 turn.
Install dust cap (77) on wheel.
Sensor Height Adjustment
1. Remove wheel (74) from LineLazer.
2. Remove sensor assembly (60).
3. Adjust sensor assembly height with two 17 mm
nuts of sensor so bottom surface of sensor is
0.638 +/–0.020 from bottom surface of shield.
Torque to 8 +/– 2 in-lb.
Ç Ç
Ç Ç
Ç Ç Ç Ç
Ç Ç Ç Ç
Ç Ç
Ç Ç Ç Ç
Ç Ç Ç Ç
Ç Ç
Ç Ç
Ç
Distance
Ç
Sensor
Ç Ç
Tire
Ç Ç
.638 in.
Ç
Ç
Ç
Ç
Ç
Ç
Ç
Ç
Ç Ç
59
Gear
Ç
ti3680a
Tabla de contenido
