Manual Operation - Kingfisher INTERNATIONAL KI7010B Guía De Referencia Rápida

QUICK REFERENCE GUIDE: KI7600C SERIES OPTICAL POWER METER

MANUAL OPERATION

•
To remove interchangeable connector adaptor, press button on rear of case
and pull off adaptor. This may be easier with a test lead attached.
•
To defeat auto power-off, hold [POWER] for 3 seconds at turn on until 'ON'
and 'Perm' are displayed.
•
Low battery is indicated with a battery symbol
•
To select operational wavelength, press [Power Meter], [-/+].
•
To set reference, press [ABS/REL] and hold [SET REF] for 3 seconds. Meter
displays about 0.00 dB R
•
To stop / start display update, press [HOLD].
•
If a test tone is detected, meter will display 'Hz'.
•
To toggle log / linear display mode, press [dB/W].
•
To display minimum and maximum recorded power for selected wavelength,
press [ ] and [Max/Min]. Press [
re-start recording.
AUTOTEST OPERATION
•
To initiate Autotest, connect Power Meter to Light Source and press
[Autotest] on Light Source.
•
To show one wavelength only, scroll [-/+]. Press [Menu] to exit.
•
Autotest remains for 8 seconds after signal loss, to allow quick connection
change.
] [Max/Min] and hold for 3 seconds to
•
To exit Autotest, remove test lead for >8 seconds, or on the Light Source,
press [MENU].
MEMORY OPERATION
•
Data can be stored in Power Meter and Autotest modes, however, memory
recall and cancel functions are not available in Autotest.
•
To clear all memory, press both [MR] and [Exit] simultaneously for 3
seconds. 'clr' will display.
•
To store in next default location, press [M+].
•
To change next store location, press [◄►] [-/+] [Set] or [Menu].
•
To recall, press [MR] and [-/+] to scroll memory.
•
Exit Autotest and enter Power Meter mode to read or cancel memory.
•
Autotest memory recall: use [-/+] to scroll wavelengths.
•
To exit memory display, press [Menu].
VISIBLE LASER OPTION
•
Select [POWER], [SOURCE].
•
To stop modulation, press [MOD]. To change modulation frequency, press
[ ] and [KHz] on the hidden keypad. Use [+/-] to scroll modulation
frequencies, then press [Set] to store.
•
To turn off laser, press [-/+]
English
65