Manual Operation; Memory Operation - Kingfisher INTERNATIONAL KI7010B Guía De Referencia Rápida

QUICK REFERENCE GUIDE: KI7400C / 7800C SERIES OPTICAL LIGHT SOURCE

MANUAL OPERATION

•
To remove interchangeable connector adaptor, press button on rear of case
and pull off adaptor. This may be easier with a test lead attached.
•
To defeat auto power-off, hold down [POWER] for 3 seconds at turn on until
'On' and 'Perm' are displayed.
•
Low battery is indicated with a battery symbol.
•
To enable source, select [POWER], [Source].
•
To change wavelength, press [-/+].
•
To activate modulation, press [Mod].
•
To change modulation frequency, while source is active press [ ] [KHz] [-/+]
[Set] or [Menu].
•
To change laser power level, while source is active press [ ] [Level] [-/+]
[Set] or [Menu].
AUTOTEST OPERATION
•
To initiate Autotest, connect Power Meter to Light Source and press
[Autotest] on Light Source.
•
Autotest remains for 8 seconds after signal loss, to allow quick connection
change.
•
To exit Autotest, remove test lead for > 8 seconds, or press [MENU].

MEMORY OPERATION

•
Data can be stored in Source and Autotest modes, however, memory recall
and cancel functions are not available in Autotest.
•
To clear all memory, press both [MR] and [Exit] simultaneously for 3
seconds. 'clr' will display.
•
To store in next default location, press [M+].
•
To change next store location, press [◄►] [-/+] [Set] or [Menu].
•
To recall, press [MR] and [-/+] to scroll memory.
•
Exit Autotest and enter Source mode to read or cancel memory.
•
Autotest memory recall: use [-/+] to scroll wavelengths.
•
To exit memory display, press [Menu].
English
12