Chicco ALWAYS WITH YOU Manual De Instrucciones página 15

- 3 LED level indicator for sounds emitted by the
child (4):
They light up indicating 3 levels of sound intensity
detected by the child unit microphone (5).
They allow parents to monitor sounds emitted by
the child even when the parent unit (6) loudspeak-
er volume is switched off.
: the first LED lights up if sounds emit-
ted by the child are of a relatively low
intensity.
: the first and second LED light up if
sounds emitted by the child are of a
medium intensity.
: the first, second and third LED light up
if sounds emitted by the child are of a
relatively high intensity.
Warning!
After switching the parent unit on, always
make sure that the child unit is on.
After switching on the unit, always check that
reception of the transmitted signal is possible
at the distance and/or in the areas within where
it has been set. It is advisable to carry out a test
with the help of a family member from the room
where the child unit has been placed, moving si-
multaneously with the parent unit in areas where
it has been set, to verify correct reception of the
transmitted signal.
3. Fitting and replacing the rechargeable bat-
teries in the parent unit.
Warnings: These steps must be done
only by an adult.
Warning: RECOMMENDATIONS FOR
BATTERY USE
- Use only rechargeable NiMH batteries for the
code 20256300100 parent unit.
- Always remove the rechargeable batteries when
flat and/or when you will not be using the prod-
uct for an extended period of time. This prevents
flat batteries from leaking the liquid they contain
and damaging the parent unit and/or objects
nearby.
- Do not short-circuit the battery poles.
NB: if the duration of rechargeable batteries sup-
plied with the parent unit is reduced excessively,
they have run out and therefore must be replaced
(this is to be considered normal because recharge-
able batteries run out over time).
- The rechargeable batteries supplied with the
parent unit must be recharged using the mains
adapter (1) supplied only (code 20256300200).
- Do not attempt to recharge non-rechargeable
batteries: they may explode.
- This product is not designed to work with lithium
batteries.
WARNING: improper use may create
hazardous conditions.
- Never leave flat rechargeable batteries in the par-
ent unit. Recharge immediately (or replace if run
out) as they could leak corrosive and/or danger-
ous liquids.
- If the batteries should leak liquid, adequately pro-
tect hands and replace the batteries immediately,
taking care to thoroughly clean the battery com-
partment and anything else touched by the liq-
uid. Wash your hands thoroughly when finished.
Do not mix batteries of different brands or types
and flat batteries with new ones.
- Insert the 3x1.2 V, NiMh, 550 mAh, AAA recharge-
able batteries (included) in the parent unit, mak-
ing sure that the insertion polarity is as indicated
in the battery compartment.
- Remove rechargeable batteries from the product
before disposing of it.
- Do not leave rechargeable batteries and/or any
tools for their removal within the reach of chil-
dren.
- Do not dispose of rechargeable batteries in fire
or throw them away carelessly or in the house-
hold waste.
- Recycle used batteries in accordance with ap-
plicable laws.
- In case of prolonged non-use of the product, al-
ways remove the batteries.
3.1 Fitting the rechargeable batteries sup-
plied in the parent unit.
Upon purchase, the rechargeable batteries (9) in
the parent unit are kept separately in the product
packaging.
Carefully remove the rechargeable batteries (9)
from their packaging.
Remove the battery compartment closing panel
(7), placing your finger near the top groove and
gently pulling the panel outward (fig.1). Insert two
1.2 V rechargeable NiMH batteries, respecting the
proper insertion polarity as indicated in the battery
15