Moulinex Compact Chef Manual Del Usuario página 33

PROBLEMS
Leak through the motor-unit lid.
Smell from the motor.
" SECU" appears on the display.
1
" SECU" displayed + red warning light
2
on.
"Err1" is displayed.
"Err2" is displayed.
The safety lock indicator appears (C3)
on the LDC display.
CAUSES
Too many ingredients have been added.
The sealing ring is not present.
The sealing ring has been cut or is
damaged.
A problem with the accessories.
When first using the appliance, or in
the event of motor overload caused by
adding too many ingredients, or pieces
that are too large.
A motor overload caused by adding too
many ingredients or pieces that are too
hard or large, or processing succession
of recipes without sufficient cooling
time.
The temperature sensors can overheat
due to the jug heating up if it is
empty, or if it has too few ingredients
or too little liquid in it.
The temperature sensor no longer
works.
The jug is very hot.
The jug or motor-unit lid has not
locked into place properly.
Motor overload.
31
SOLUTIONS
Reduce the quantity of ingredients
added.
Position the sealing ring on the
seal-mounting cup and clip to the
motor-unit lid.
Replace the sealing ring - contact an
authorised service centre.
Check that you are using the
recommended accessory.
Leave the motor too cool (for about 30
minutes) and reduce the quantity of
ingredients in the jug.
Allow the motor to cool down
(approximately 30 minutes) and
reduce the quantity of ingredients
in the jug, check that you are using the right program, as well as the
recommended accessory and that you
are not exceeding the capacity of the
appliance.
Add more ingredients or a bit of liquid
to the jug.
Contact an authorised service centre.
Switch off the appliance and let the
jug cool down. Do not operate your jug
when it is empty. Add the ingredients
to the jug or even a little liquid.
Check that the jug is correctly
positioned on the base and that the
motor-unit lid is correctly locked in
place (the padlock will no longer
appear on the screen).
Allow the motor to cool down
(approximately 30 minutes) and reduce
the quantity of ingredients in the jug,
check that you are using the right
program, as well as the recommended
accessory.
You are sure that everything is
assembled correctly but the problem
persists (the padlock can be seen on
the display), in this case, contact an
approved service centre.
EN