Uline H-2272 Manual Del Usuario página 2

1. Open cover to expose inside of decorator strip
window.
2. Slide decorator strip into place, making sure the
decorator strip is held by the plastic guides.
(See Figure 5)
3. Close cover firmly and lock.
NOTE: Recommended mounting height is 52"
from the floor to the bottom of the dispenser.
If using template, recommended mounting
height is 52" from floor to bottom edge shown
on template. (See Figure 8)
NOTE: Ensure that proper mounting hardware
is used for appropriate wall composition as
enclosed hardware may not be compatible
with your wall surface.
1. Insert the key into the lock opening on the top of
dispenser and push until cover pops open. If push
button is installed, gently push the button until the
cover opens. (See Figure 6)
Figure 6
2. Tape mounting template to wall at desired height
and ensure that template is level. (See Figure 7)
Figure 7
PAGE 2 OF 9
DECORATOR STRIP INSTALLATION
MOUNTING
Recommended
Mounting
Locations
Figure 5
Decorator Strip
3. Pre-drill mounting holes if necessary and remove
template. Insert wall anchors if necessary. (See Figure 8)
Figure 8
4. Position dispenser over holes or markings on wall and
insert screws through holes in dispenser and tighten.
(See Figure 9)
Figure 9
Decorator Strip
Window
0721 IH-2272