Uline H-2557 Manual De Instrucciones
  1. Manuales
  2. Marcas
  3. Uline Manuales
  4. Dispensadores
  5. H-2557
  6. Manual de instrucciones
Uline H-2557 Manual De Instrucciones

Uline H-2557 Manual De Instrucciones

Ocultar thumbs
1
2
3
4
5
6
Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

H-2557
FOAMING SOAP
PUSH DISPENSER
(FOR OPTIONAL FASTENER INSTALLATION. NOT INCLUDED)
TOOL NEEDED
Drill with 1/4" Bit
TAPE INSTALLATION
Use only on smooth, dry surfaces
1. Install the dispenser at least 10"
Figure 1
(25.4 cm) above counter top. (See
Figure 1)
2. Clean installation surface with
supplied prep pad. Allow surface
to dry for 60 seconds.
10 in.
3. Peel paper off of installation
tape and press dispenser firmly into
position. (See Figure 2)
Figure 2
4. Open dispenser by inserting key
into key access holes and push up
until front cover opens.
(See Figure 3)
Figure 3
5. Press firmly on back plate for 30
seconds. For maximum adhesion,
do not load refill for 24 hours. (See
Figure 4)
Figure 4
PAGE 1 OF 6
1-800-295-5510
uline.com
PARTS NEEDED
Type A
#10 x 1" Anchors x 4
#10 x 1" Screw x 4
INSTALLATION
FASTENER INSTALLATION (PARTS NOT INCLUDED)
Use on rough or smooth surfaces
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
1. Open dispenser by pushing on
Figure 5
cover latch until it releases.
(See Figure 5)
2. Using backplate as template,
mark and drill 4 center holes
using 1/4" spiral masonry drill or
1/4" wood drill. If required, pierce
installation tape at installation
holes. Make sure tape backing
remains in place.
3. Install #10 x 1" anchors into the
4 drilled holes. Insert Type A
Figure 6
#10 x 1" screws into installation
holes in backplate and through
installation tape. (See Figure 6)
4. Peel paper off of installation
tape, line up screws with
anchors, and press firmly into
position. (See Figure 7)
Figure 7
5. Tighten screws securely, being
Figure 8
careful not to overtighten.
(See Figure 8)
0421 IH-2557
loading

Manuales relacionados para Uline H-2557

Resumen de contenidos para Uline H-2557

  • Página 1 Para Español, vea páginas 3-4. Pour le français, consulter les pages 5-6. H-2557 1-800-295-5510 uline.com FOAMING SOAP PUSH DISPENSER (FOR OPTIONAL FASTENER INSTALLATION. NOT INCLUDED) TOOL NEEDED PARTS NEEDED Drill with 1/4" Bit Type A #10 x 1" Anchors x 4 #10 x 1"...
  • Página 2 Figure 11) Figure 9 2. After assembled, push up until 2. Push up until front cover opens. front cover opens. (See Figure 12) (See Figure 10) Figure 11 Figure 10 Figure 12 1-800-295-5510 uline.com PAGE 2 OF 6 0421 IH-2557...
  • Página 3 H-2557 800-295-5510 uline.mx DESPACHADOR MANUAL DE JABÓN ESPUMOSO (PARA INSTALACIÓN OPCIONAL CON ANCLAJES. NO INCLUIDOS). HERRAMIENTA NECESARIA PARTES NECESARIAS Taladro con 4 Tornillos de 4 Anclajes #10 x 1" Broca de 1/4" #10 x 1" Tipo A INSTALACIÓN COLOCACIÓN CON CINTA ADHESIVA INSTALACIÓN CON FIJADORES (NO INCLUYE PARTES)

  • Página 4: Opciones De Cierre

    Diagrama 11) la tapa delantera se abra. (Vea Diagrama 10) Diagrama 11 2. Una vez ensamblado, empújelo hacia arriba hasta que la tapa Diagrama 10 delantera se abra. (Vea Diagrama 12) Diagrama 12 800-295-5510 uline.mx PAGE 4 OF 6 0421 IH-2557...
  • Página 5 H-2557 1-800-295-5510 uline.ca DISTRIBUTEUR DE SAVON MOUSSEUX AVEC BOUTON POUSSOIR (POUR L'INSTALLATION PAR FIXATION OPTIONNELLE. NON COMPRIS) OUTIL REQUIS PIÈCES REQUISES Perceuse avec Vis de type A Chevilles d'ancrage mèche de 1/4 po n° 10 x 1 po x 4 n°...

  • Página 6: Options De Verrouillage

    2. Poussez vers le haut jusqu'à ce Figure 11) que le couvercle avant s'ouvre. (Voir Figure 10) Figure 11 2. Une fois assemblé, poussez Figure 10 vers le haut jusqu'à ce que le couvercle avant s'ouvre. (Voir Figure 12) Figure 12 1-800-295-5510 uline.ca PAGE 6 OF 6 0421 IH-2557...