Tabla de contenido
Assembly of the Tool
1. If required, replace the Bearing Preload Spring (42)
and the Bevel Pinion Front Bearing (40).
2. Place the Bevel Pinion, geared end first, into the
Piston Housing Assembly (41).
3. Make sure that the bevel gears engage by pressing the
Bevel Pinion into the Housing hard and turning. If
they make contact, the saw blade end of the Piston
Assembly (49) will move. If there is no movement,
turn the Adjusting Screw Assembly (47) into the
Housing while turning the Gear.
4. Rotate the Motor Locating Screw (19) until the Bevel
Pinion (38) protrudes 1–7/32" (31 mm) beyond the
face of the Motor Housing (1).
MAINTENANCE SECTION
5.
Secure the Piston Housing to the Motor Housing by
tightening two Piston Housing Long Cap Screws (62)
and two Piston Housing Short Cap Screws (63).
6.
Once the Tool is properly assembled and lubricated:
a. Run the tool and tighten or loosen the Adjusting
b. Slowly rotate the Adjusting Screw until the tool
c. Shut the tool off and tighten the Adjusting Screw
18
Screw Assembly to get the proper bevel gear
engagement.
runs quietly and there is no apparent gear whine.
Lock (48).
Tabla de contenido
