THERMEx MINI PERPIGNAN Instrucciones De Uso página 47

B 540231181226012016
Periodic extraction is turned off by holding down the (-)-symbol for approx. five seconds. When the panel indicator stops flashing, periodic extraction
is turned off.
AFTER-RUNNING
After-running means that the motor will stop automatically a given number of minutes after this function has been activated. After-running can run
from 10 to 90 minutes, and runs at the selected speed.
After-running is activated in the following way:
• Switch on the hood to the desired speed.
• Press on the symbol on/off after-run.
• The indicator will now flash with the number 0.
• Use the (+)- and (-)-symbols to adjust the time that the after-run function shall run. If '1' is selected, the after-run will run for 10 minutes, if '2' is
selected, after-run runs for 20 minutes, etc. The after-run function can be set for a maximum of 90 minutes.
• Confirm the selected time by pressing on the on/off after-run symbol.
• The indicator of speed will now display the speed at which the motor runs at and the panel indicator will flash to indicate that the after-run
function is activated.
The after-run function can be interrupted earlier than requested by pressing on the on/off after-run symbol or by switching off the hood, as described
in the section EXTRACTION on page 8. If the after-run function is interrupted, then the panel indicator will stop flashing.
Should it be desirable to regulate the speed of the after-run function after it has been activated, then this is done using the (+)- and (-)-symbols until
the desired speed has been reached. The panel indicator will continue to flash to indicate that the after-run function is activated.
RECIRCULATION
The hood can be used for recirculation. This is used in kitchens and locations where there is no possibility of venting into open-air. The air is sucked
first through the grease filter and then through a filter with activated carbon which removes odours.
NOTE: Two recirculation filters must be used, and these are not included in the purchase of the hood, although they can be bought as accessories. The
product number on a set of recirculation filters is 535.23.0550.9.
The recirculation filters are installed on the motor inside the hood as follows:
1
Open the bottom glass door and remove the
steel filter.
2
Install the two recirculation filters by rotating
them onto the flanges on the sides of the
motor.
THERMEX MINI PERPIGNAN & MINI BORDEUAX
3
Replace the steel filter inside the hood and
close the glass door.
47