Identification Plate; Operating Controls; Start-Up; Assembly - MTD BLB40 Instrucciones De Funcionamiento Originales

Identification plate

Identification plate
Position
The identification plate is located on the leaf blower
casing.
Note
The label has the status of a certificate. It
must never be altered or obliterated.
Layout
1 Manufacturer
2 Disposal note
3 CE label
4 Guaranteed sound level
5 Year of manufacture
6 Degree of protection
7 Model number
8 Motor rotation speed in rpm
9 Rated voltage, current type
10 Weight
11 Power
12 Serial number
13 Model name

Operating controls

Operating controls E
1 Handle
2 On/off switch with motor speed function
3 Blowing tube locating button
4 Blowing tube
5 Battery pack
6 Leaf blower casing
Supplementary documentation
Make sure the operating manuals of the
40V FAST CHARGER and the 40V LI-ION
power pack are available. Please read
and understand them before putting the
device into use.
Power pack charging
Risk of injuries or material damage
¾ Only charge the power pack with the 40V
FAST CHARGER.
Attention!
The power pack is supplied partially charged.
Before first use, fully charge the power pack
using the 40 V FAST CHARGER to ensure the full
capacity of the power pack.
Power pack charging must be carried out ac-
Î
cording to the instructions in the supplementary
documentation.
Operating times
Observe local regulations.
Î
Check with your local authorities to determine if
Î
there are any operating time limitations.

Assembly

Assembly A
Pick up the leaf blower casing and press the
Î
locating button.
Press the blowing tube on to the leaf blower
Î
casing 1 .
Insert the power pack B
Incorrect handling of the power pack and
the charger
ÂRisk of injuries and material damage
¾ Read and observe the operating
instructions of the power pack and
charger.
Push the power pack into the power pack com-
Î
partment, until it audibly engages 1 .
ü The power pack is in operating mode.
• The electrical contacts are closed and the de-
vice is ready for use.

Start-up

WARNING!
WARNING!
EN
17