Preparing For Use; Installing The Product - LIVARNO LUX HG04243A Instrucciones De Montaje

the rechargeable battery
after charging (see "Replacing the rechargeable battery").

Preparing for use

Note: The solar cell
motion sensor
3
The "ON" position for the ON / OFF switch
the following functions:
If the orientation light is constantly lit up, it will automatically switch
on or off once the solar cell
long operating life, the LEDs will not be fully powered in this setting.
If the rechargeable battery is fully charged, the charge will be suffi-
cient for approx. 6 hours of lighting. As soon as the motion sensor
detects movement, the product will switch to particularly bright light
(see Fig. H). While the particularly bright light is switched on, the
LEDs will be run at full power. Approx. 40 seconds after the last
movement has been detected, the product will return to functioning
as a constantly lit-up orientation light.

Installing the product

Install the product in accordance with Figures A, E:
1. Rotate the solar cell housing
shade (see Fig. A).
5
2. Move the ON / OFF switch
the product switching on during darkness.
3. Insert the solar cell housing
tighten by turning it clockwise.
4. Take out the base
lamp body
5. Insert the base
24 GB/MT
9
also works as a twilight sensor, while the
2
only responds to movement.
detects dusk or dawn. To ensure a
2
1
with ground spike
11
.
6
into the bottom of lamp body
11
if the light output does not improve
anticlockwise out of the lamp
4
into the "ON" position to enable
into the lamp shade
4
which is inside the
12
features
1
3
and
5
.
6