Section V Shell Installation; Sash Window - Friedrich SH14 Manual De Uso, Cuidado E Instalación

SECTION V — SHELL INSTALLATION
STEP 1. Check the window sill and frame to be sure they are in good condition and firmly anchored to the wall. Repair if
necessary.
STEP 2. CABINET MOUNTING: Raise the lower window sash 1/4" more than the height of the cabinet. Carefully slide
the cabinet through the open window until the sill plate channel rests behind the window sill and the top support
angle rests against the window (See Figure D). Center the cabinet side to side and drill three (3) 5/32" dia. pilot
holes into the window sill using the holes in the cabinet sill plate as a guide. Install three (3) #12A x 2" long screws
(Item #4) (See Figure D).
FIGURE D
Drill 3 5/32" pilot holes and install 3
#12A x 2" long screws (Item #4)
FIGURE E
A 1" x 4" or 2" x 4" spacer should be used between the
wall and bracket when installed on aluminum, asbestos
or vinyl siding.
STEP 3. OUTSIDE SUPPORT MOUNTING: Assemble the support brackets (Item #1) to the bottom rails of the cabinet
with four (4) 10-24 1" long screws (Item #2) and four (4) 10–24 flat nuts (Item #3). Adjust the support brackets to
bring the bottom pads in contact with the wall surface. (See Figure E.)
A 1" x 4" or 2" x 4" SPACER SHOULD BE USED BETWEEN THE WALL AND THE SUPPORT BRACKETS WHEN
INSTALLED ON ALUMINUM OR VINYL SIDING).
with two (2) #12A x 2" long screws (Item #4). Adjust the support brackets to provide an approximate 3/8" (10 mm) down
slope towards the outside for drainage. Tighten all screws. (See Figure E).
(A) SASH WINDOW INSTALLATIONS
SHELL (CABINET) INSTALLATION – STANDARD SASH WINDOWS
Center cabinet side to
side in window
Window sill
Locate the sill plate guide channel
just back of the window sill.
#12A x 2" Screw (Item #4)
3/8" (10 mm)
Down slope
Support
Bracket
Drill 5/32" (4 mm) dia. pilot holes, and secure the brackets to the wall
Top Support Angle
Pull window sash down behind
the top support angle
Side Support Angle
Support
Bracket
(Item #1)
10 - 24 Flat Weldnut (Item #3)
10 - 24 x 1" Hex Head Screw (Item #2)
Page 11