Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Translation of the
Original Operating Instructions
Long-neck angle grinder LHW
Dear customer!
Always keep these operating instructions and the en-
closed safety guidelines within reach.
Only use this device with exact knowledge of it and
comply with the instructions and safety guidelines!
This is necessary to ensure safe operation and, second-
ly, it simplifies familiarisation with the device and its
functions.
Proxxon assumes no liability for the safe function of the
device in the case of:
• handling that does not comply with normal intended use,
• use for other purposes not mentioned in the manual,
• incorrectly executed repairs,
• ailure to heed safety instructions,
• external influences for which the manufacturer is not
responsible
We recommend using PROXXON original spare parts
for all repair and maintenance work.
Repairs should only be performed by qualified skilled
personnel!
Please note: All information contained in these operat-
ing instructions - especially the technical data - corre-
sponds to the status at the time of printing.
We reserve the right to make further developments in
the interest of technical progress. We wish you every
success with the device.
WARNING!
Read all safety warnings and instructions.
Failure to follow all safety warnings and in-
structions listed below may result in electric shock, fire
and/or serious injury.
KEEP ALL SAFETY WARNINGS AND INSTRUCTIONS
FOR THE FUTURE!
- 10 -
Safety guidelines for all operations
a) This power tool can be used as grinder, sander
and abrasive cutting-off tool. Please observe all
safety guidelines, instructions, illustrations and
data provided with the device. Failure to follow in-
structions listed below may result in electric shock,
fire and/or serious injuries.
b) This power tool is not suitable for working with
wire brushes and polishing Uses for which the
power tool is not intended can cause hazards and
injuries.
c) Do not use accessories which are not designed or
recommended by the manufacturer specifically
for this power tool. Just because the accessory can
be attached to your power tool does not assure safe
use.
d) The rated speed of the bits and cutters must be at
least equal to the maximum speed specified on
the power tool. Accessories that turn faster than
their rated speed can break and fly apart.
e) The outside diameter and thickness of the bits and
cutters must be within the capacity rating of your
power tool. Incorrectly sized bits and cutters can-
not be adequately guarded or controlled.
f) The arbour size of discs, flanges, grinding discs
or other accessories must properly fit the grinding
spindle of your power tool. Bits and cutters that do
not fit the grinding spindle of the power tool prop-
erly will turn unevenly, vibrate very strongly and
cause loss of control.
g) Do not use damaged bits and cutters. Before each
use, inspect bits and cutters such as sanding
discs for chips and cracks, grinding discs for
cracks, strong wear or tear, wire brushes for loose
or broken wires. If the power tool or bits and cut-
ters are dropped, check for damage or install un-
damaged bits and cutters. After you have inspect-
ed and installed the bits and cutters, keep your-
self and any other persons in the vicinity away
from the plane of the rotating bits and cutters and
run the device at maximum rotational speed for
one minute. Damaged bits and cutters usually
break during this test time.
h) Wear protective equipment. Depending on the ap-
plication, use full face protection, eye protection
or protective goggles. If appropriate, wear a dust
mask, hearing protection, protective gloves or a
special apron capable of stopping small abrasive
and material particles. The eyes are to be protect-
ed from flying debris generated during various op-
erations. Dust masks or respirators must filter the
Tabla de contenido
