Tabla de contenido
Idiomas disponibles
Idiomas disponibles
IMPORTANT ChARGING NOTES
1. Longest life and best performance can be obtained if the battery pack is charged
when the air temperature is between 65°F and 75°F (18°- 24°C). DO NOT charge the
battery pack in an air temperature below +40°F (+4.5°C), or above +105°F (+40.5°C).
This is important and will prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch while charging. This is
a normal condition, and does not indicate a problem. To facilitate the cooling of the
battery pack after use, avoid placing the charger or battery pack in a warm environment
such as in a metal shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp or other appliance
b. Check to see if receptacle is connected to a light switch which turns power off
when you turn out the lights.
c. Move charger and battery pack to a location where the surrounding air
temperature is approximately 65°F - 75°F (18°- 24°C).
d. If charging problems persist, take the tool, battery pack and charger to your
local service center.
4. The battery pack should be recharged when it fails to produce sufficient power on
jobs which were easily done previously. DO NOT CONTINUE to use under these
conditions. Follow the charging procedure. You may also charge a partially used pack
whenever you desire with no adverse affect on the battery pack.
5. Foreign materials of a conductive nature such as, but not limited to, steel wool,
aluminum foil, or any buildup of metallic particles should be kept away from charger
cavities. Always unplug the charger from the power supply when there is no battery
pack in the cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
wARNING:
Shock hazard. Do not allow any liquid to get inside charger..Never.
attempt.to.open.the.battery.pack.for.any.reason..If.the.plastic.housing.of.the.
battery.pack.breaks.or.cracks,.return.to.a.service.center.for.recycling.
20VOLT MAx**
INSTALLATION AND REMOVAL
Of ThE BATTERy PACk
TO INSTALL BATTERy PACk:
pack into the flashlight until an audible click is heard
(figure E). Make sure battery pack is fully seated and
fully latched into position.
TO REMOVE BATTERy PACk:
battery release button as shown in figure f and pull
battery pack out of the flashlight.
OPERATING INSTRUCTIONS
ON/Off BUTTON
To turn the light on, press the on/off button (1 or 4).
To turn it off, press the button again.
12VOLT MAxx*
PIVOTING ThE 10 LED LIGhT hOUSING
(fIGURE G)
The LED light housing (2) can be pivoted by moving lifting it
to different positions within the 115 degree pivot range.
E
Insert battery
Depress the
9
F
G
Tabla de contenido
