Electrical Requirements - Emerson BUILDER Serie Manual Del Propietário

1. Unpacking Instructions
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver
One Standard screwdriver
Materials
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be
a 3-conductor (2-wire with ground) of following size:
Installed Wire Length
Up to 50 ft.
50-100 ft.
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit.
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked "Acceptable for
Fan Support of 22.7 kg. (50 lbs.) or less", and use
screws supplied with outlet box. Most outlet boxes
commonly used for support of light fixtures are not
acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
One stepladder
One wire stripper
Wire Size A.W.G.
14
12

2. Electrical Requirements

(Continued)
!
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 13). If you feel
you do not have enough wiring knowledge or
experience, have your fan installed by a licensed
electrician.
Controls (Sold Separately)
SW46 Wall Control and SW90 Wall Control (both sold
separately) may be used with this 52" Builder Series
Ceiling Fan. Controls are recommended for indoor use
only. This 52" Builder Series Ceiling Fan is light fixture
adaptable (sold separately).
The outlet box must be securely anchored and capable
of withstanding a load of at least 50 pounds.
If your fan is to replace an existing ceiling light fixture,
turn electricity off at the main fuse box at this time and
remove the existing light fixture.
!
To avoid fire or shock, follow all wiring instructions
carefully.
Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
Please call Emerson
1-800-654-3545 if you have any questions about
installation and operation of this ceiling fan.
4
WARNING
WARNING
technical support
U.L. Model No.: 52-ANT
at