Emerson BUILDER Serie Manual Del Propietário página 8

3. Ceiling Fan Assembly
3.9
Mount the Blade Flange to the Fan Blade using three
M5 x 6mm Washer Head Screws (supplied) (Figure 8).
Repeat this procedure for other four Fan Blades and
Blade Flanges.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not insert
foreign objects in between rotating fan blades
3.10
Rotate the Motor Hub until the Flange Screw Hole is
next to the cutout in the Switch Housing Plate.
Attach one Blade Assembly to the Motor Hub using two
M6 x 12mm Flange Screws with Lockwashers in Flange
(Figure 9).
Make sure the Screws are NOT tightened.
Repeat this procedure for the other four Blade
Assemblies.
NOTE: The blade flanges have an interlocking
feature that must be fully engaged before
tightening the screws. Make sure all the flanges are
properly engaged and then tighten the flange
screws. If one of the flanges does not seat properly
on the motor hub, loosen the adjacent flange
screws, re-engage and reseat the flanges, then
tighten the screws again.
(Continued)
M5 x 6mm WASHER HEAD
BLADE SCREW (3)
BLADE FLANGE
Figure 8
M6 x 12mm FLANGE SCREWS
WITH LOCKWASHERS
(2 per blade assembly)
Figure 9
8
FAN
BLADE
MOTOR
HUB
SWITCH
HOUSING
PLATE
U.L. Model No.: 52-ANT