Lorex L19WD Serie Manual De Instrucciones página 60

Appendix 3: Setting Up Remote Viewing
How do I enable Port Forwarding?
You need to enable port forwarding on your router to allow for external communications with
your system for the following port:
• PORT 5000
Computers, DVRs, and other devices inside your network can only communicate directly with
each other within the internal network. Computers and systems outside your network cannot
directly communicate with these devices. When a system on the internal network needs to send
or receive information from a system outside the network (i.e. from the Internet), the information
is sent to the router.
NETWORK EXAMPLE
Router
Internal IP
192.168.0.1
INTERNET
When a computer on the Internet needs to send data to your internal network, it sends this data
to the external IP address of the router. The router then needs to decide where to send this data.
This is where setting up Port Forwarding becomes important.
Port Forwarding tells the router to which device on the internal network to send the data. When
you set up port forwarding on your router, it takes the data from the external IP address:port
number and sends that data to an internal IP address:port number (i.e. Router External IP
216.13.154.34:6100 to DVR Internal IP 192.168.0.103:6100).
The instructions found online in the Router Configuration Guides will assist you in the port
forwarding configurations for a selection of different router models. Visit our Consumer Guides
Support website at http://www.lorexcctv.com/support
60
Router
Internal IP
192.168.0.1
INTERNAL
NETWORK
for more details.
PC
Internal IP
192.168.0.102
SYSTEM
Internal IP
192.168.0.103