Wood Stud Installation; Concrete Installation - CHIEF iC Serie Manual De Instrucciones

Installation Instructions
1
1
x2
2
1/4" (6.3mm)
H x 2
3
9/16" (14.2mm)
1A
x 2
1
x 2
2
3/8" (10mm)
H x 2
4
G x 2
9/16" (14.2mm)
x2
B
G x 2
3
F x 2
B
INSTALL BASE PLATE TO WALL

Wood Stud Installation

WARNING:
FAILURE TO PROVIDE ADEQUATE
STRUCTURAL STRENGTH FOR THIS COMPONENT
CAN RESULT IN SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installer's
responsibility to make sure the structure to which this
component is attached can support five times the combined
weight of all equipment. Reinforce the structure as required
before installing the component.
1. Level base plate (B) and mark locations of pilot holes.
2. Drill two 1/4" (6.3mm) diameter pilot holes into wood studs
at marks.
3. Using 9/16" (14.2mm) socket wrench, install two lag
screws (G) through two flat washers (H) and base plate
(B) into wood studs.

Concrete Installation

WARNING:
FAILURE TO PROVIDE ADEQUATE
STRUCTURAL STRENGTH FOR THIS COMPONENT
CAN RESULT IN SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installer's
responsibility to make sure the structure to which this
component is attached can support five times the
combined weight of all equipment. Reinforce the structure
as required before installing the component.
1. Level base plate (B) and mark locations of pilot holes.
2. Drill two 3/8" (10mm) diameter pilot holes into mounting
surface.
3. Install two anchors (F) into pilot holes.
4. Using 9/16" (14.2mm) socket wrench, install two screws
(G) through two flat washers (H) and wall plate (B) into
two anchors (F).
CAUTION:
Do NOT overtighten screws!
iCMPDA2
11