AL-KO BC 225 L Traducción Del Manual De Instrucciones Original página 19

BC 225 L assembly
Parts overview
(Fig. 1)
1 String head
2 Driver
3 Guard
4 „Bike" grip
5 Lever, see Starting the engine
Caution!
The machine must not be operated before assembly
work has been completed.
Mounting the L grip (BC 225 L)
1. Place the rubber sleeve over the support bar.
2. Screw together the lower half of the grip and the top
half above the rubber sleeve using the four Allen
screws.
Mounting the guard (BC 225 L)
1. Fix cover and mounting sleeve with the center hexa-
gon socket screw on the stem and tighten.
2. Screw protection cover with the remaining two hexa-
gon socket screws
Mounting the string head (BC 225 L)
1. Hold the driver disc with your hand.
2. Screw the string head onto the guide pin.
Caution: Left-hand thread.
20
BC 225 B assembly
Parts overview
„Bike" grip
(Fig. 2)
1. Place the rubber sleeve over the support bar.
2. Screw together the lower brace and the grip holder
3. Place the grip rod into the grip holder.
4. Fasten the upper brace onto the grip holder using the
(Fig. 3)
Mounting the cutting blade
1. Place the drive plate onto the guide pin on the drive
2. Place the cutting blade onto the drive plate so that the
(Fig. 4)
3. Push the flange onto the cutting blade so that the flat
4. Fit the fan washer.
5. Secure the clamping nut onto the guide pin. To do
6. Secure the nut with the cotter pin.
Mounting the guard
1. Fix protection cap with medium screw on the hand-
2. Protective cover with the remaining two hex screws
Mounting the string head
Translation of the original operating instructions
(Fig. 1)
1 String head
2 Drive shaft
3 Guard
4 "Bike" grip
5 Lever, see Starting the engine
Caution!
The machine must not be operated before assembly
work has been completed.
(Fig. 2) (Fig. 3
over the rubber sleeve using the four Allen screws.
four Allen screws.
shaft.
hole in the cutting blade is positioned precisely on the
guide circle on the drive plate.
side faces the cutting blade.
this, insert the Allen key into the relevant holes and
tighten using the spark plug wrench provided. Cauti-
on: left-hand thread!
(Fig. 6)
lebar.
and hex nuts tighten.
)
(Fig. 5)
(Fig. 7)