EGO BBA2100 Manual Del Usuario página 9

MOUNTING THE BRUSH ROLLERS
1. Push the drive axle onto the driven shaft (Fig. E).
Fig. E parts description see below:
E-1 Driven Shaft
E-2 Drive Axle
2. To secure the drive axle to the driven shaft, insert the
lock pin into the locking hole.
NOTICE:
The lock pin needs to be installed into place (Fig. F).
Fig. F parts description see below:
F-1 Lock Pin
F-2 Locking Hole
3. Follow the same steps to mount the other drive axle.
4. Push the brush roller onto the drive axle (Fig. G).
Fig. G parts description see below:
G-1 Brush Roller
G-2 Drive Axle
5. Insert the hitch pin into the hole at the end to secure
the brush roller to the drive axle (Fig .H).
Fig. H parts description see below:
H-1 Hitch Pin
6. Follow the same steps to mount the other brush roller.
CONNECTING THE BRISTLE BRUSH ATTACHMENT
TO THE POWER HEAD
WARNING:
Never attach or adjust any attachment
while the power head is running or with the battery
installed. Failure to stop the motor and remove the
battery may cause serious personal injury.
This bristle brush attachment is designed for use with
EGO Power Head PH1400E
1. Stop the motor and remove the battery pack.
2. Loosen the wing nut on the power head coupler.
3. If the end cap is on the attachment shaft, remove it
and save it in a safe place for later use.
Align the arrow on the bristle brush shaft with the arrow
on the coupler (Fig. I) and push the bristle brush shaft into
the coupler until you hear a clear "CLICK" sound (Fig. J).
Fig. I parts description see below:
I-1 Shaft-Release Button
I-2 Arrow on the Coupler
I-3 Wing Nut
I-4
Arrow on the Attachment Shaft
I-5 Red Line
Fig. J parts description see below:
J-1 Red Line
4. Slightly pull the shaft of the bristle brush attachment
to verify that it is securely locked into the coupler. If
not, move the bristle brush shaft back and forth in
the coupler until a clear "CLICK" sound indicates that
it is engaged.
5. Tighten the wing nut securely.
WARNING:
Be sure the wing nut on the coupler
is fully tightened before operating the equipment;
check it periodically for tightness during use to avoid
serious personal injury.
REMOVING THE ATTACHMENT FROM THE POWER
HEAD
1. Stop the motor and remove the battery pack.
2. Loosen the wing nut.
3. With the shaft-release button depressed, pull or twist
the bristle brush attachment shaft out of the coupler
to remove it from the power head.
OPERATION
WARNING:
Do not allow familiarity with this product
to make you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection. along with
hearing protection. Failure to do so could result in objects being
thrown into your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or
accessories not recommended by the manufacturer of
this product. The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this product for the purpose listed below:
◾
Cleaning areas and paths, including uneven and
jointed surfaces.
◾
Cleaning the pavement/concrete/asphalt driveways,
walkways, and yards.
WARNING:
Dress properly to reduce the risk of
injury when operating this tool. Do not wear loose clothing
or jewelry. Wear eye protection. Wear heavy, long pants,
boots and gloves. Do not wear short pants or sandals or
go barefoot.
BRISTLE BRUSH ATTACHMENT — BBA2100
EN
9