Packing List - EGO BBA2100 Manual Del Usuario

SPECIFICATIONS
EN
Brush Drum Diameter
Cleaning Swath
Recommended Operating Temperature -15°C -40°C
Recommended Storage Temperature
Weight (including the guard)
Measured sound power level L
Sound pressure level at operator's
ear L
PA
Guaranteed sound power level L
(measured according to 2000/14/EC)
Front-assist
handle
Valuation of
vibration a
h
Rear handle
◾
The above parameters are tested and measured
equipped with power head PH1400E.
◾
The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
◾
The declared vibration total value may also be used in
a preliminary assessment of exposure.
NOTICE: The vibration emission during actual use of
the power tool can differ from the declared value in
which the tool is used; In order to protect the operator,
user should wear gloves and ear protectors in the
actual conditions of use.

PACKING LIST

PART NAME
Bristle Brush Attachment
Brush Roller
Drive Axle
Guard (with bolt)
Allen Key
Hitch pin
Lock pin
Operator's Manual
8
BRISTLE BRUSH ATTACHMENT — BBA2100
DESCRIPTION
KNOW YOUR BRISTLE BRUSH ATTACHMENT (Fig.A)
250mm
1. End Cap
560mm
2. Bristle Brush Attachment Shaft
3. Guard
4. Brush Roller
-20°C-70°C
5. Gear Box
6. Hitch Pin
5.05 kg
7. Allen Key
91.4 dB(A)
K=2.02 dB(A)
WA
ASSEMBLY
82.8 dB(A)
K=2.5 dB(A)
do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could
WA
93 dB(A)
result in serious personal injury.
0.46 m/s 2
K= 1.5 m/s
2
or create accessories not recommended for use with this
1.43 m/s 2
product. Any such alteration or modification is misuse and
K= 1.5 m/s
2
could result in a hazardous condition leading to possible
serious personal injury.
cause serious personal injury, always unplug the battery
connector from the socket when assembling parts.
power head until assembly is complete. Failure to comply
could result in accidental starting and possible serious
personal injury.
MOUNTING THE GUARD
attachment is connected to the power head.
1. Loosen and remove the bolt from the guard with the
2. Lift the bristle brush attachment shaft and remove
QUANTITY
1
3. With the slot in the guard aligned with the rib on the
2
2
1
1
2
2
4. Use the supplied Allen key to tighten the bolt
1
WARNING:
If any parts are damaged or missing,
WARNING:
Do not attempt to modify this product
WARNING:
To prevent accidental starting that could
WARNING:
Do not connect the bristle brush to the
WARNING:
Install the guard before the bristle brush
supplied Allen key (Fig. B).
the end cap from the shaft.
end of the shaft, pass the guard through the shaft
until the screw holes in the guard and in the shaft are
aligned (Fig. C & D).
Fig. C & D parts description see below:
C-1 Slot
C-2 Rib
D-1 Bolt
clockwise to lock the guard securely.