Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2
NYLON LINE REPLACEMENT
1. Do not push spool in. Hold drum and turn spool clockwise until peg
clicks and disappears from hole. Pull spool out of drum.
2. Place ends of two 15 ft. x .095 in. Crossfire
spool, one on each side of barrier.
3. Wind both lines tightly and evenly (one on each side of barrier) in the
direction of arrow on bottom of spool.
4. Place ends of lines into notches in spool, leaving 6 in. protruding.
5. Feed ends of line outward through eyelets in drum.
6. Turn inner drive so that pegs in drive align with grooves in spool, and push
spool into drum
7. Hold spool and drum securely with one hand, and pull each line to
disengage from notches.
8. Hold drum and twist spool counter clockwise until peg clicks into hole.
9. Trim lines to 8 in. length.
NYLON LINE HEAD INSTRUCTIONS
TM
trimmer lines into holes in
Tabla de contenido
