Maintenance Instructions; Repair Service - stayer AGL181 Manual De Instrucciones

gb
*Accessories shown or described are not part
of the standard delivery scope of the product. A
complete overview of accessories can be found in
our accessories program.
3_OPERATING INSTRUCTIONS
Make sure that you understand and comply with
all safety instructions.
Always use safety goggles and gloves while
using the machine.
Do not force the machine by pressing it
excessively. The weight of the tool already applies
the adequate pressure. If you force it and apply
excessive pressure, the disk might get damaged
with the hazard involved.
ALWAYS replace the disk if the tool falls down
during grinding.
NEVER knock the grinding disk or any other disks
against the work piece.
Avoid the disk bouncing or getting stuck,
especially when working at corners, sharp edges,
etc. This might cause a loss of control and abrupt
kickbacks.
NEVER use this tool with disks fur cutting wood or
any other sawing disks. With these saws, the tool
may kickback strongly and cause injuries.
The depth of one single cut may reach up to
5 mm. Adjust the pressure to the tool so that
the speed of the tool is not reduced during
its use.
After having finished the job, always switch of
the tool and wait until the disk has stopped
completely before leaving the tool.
If the tool is used continuously until the battery
cartridge has become discharged completely, let
the tool rest for 15 minute before continuing with
a charged battery.
GRINDING AND SANDING
ALWAYS hold the tool firmly with one hand at the
body of the tool and the other hand at the lateral
grip 17. Switch it on and apply the disk 10 to the
work piece.
Normally, advance maintaining the edge of the
disk 10 in an angle of about 15 degrees with
respect to the surface of the work piece.
If you force or exert excessive pressure, or
you allow the disk to become bent, get stuck
or become forced when cutting, this may
cause the motor to overheat and a
dangerous kickback of the tool.
Once the cutting operation has been carried
out, make sure that the disk has stopped
completely.
Thereafter, you can leave the tool on a surface. It
is dangerous to leave the tool on a surface before
having switched it off. If there is dust or dirt around
the tool, these may be absorbed by the tool.
Make sure that the disk does not enter into contact
with the work piece. Switch the tool on and hold it
firmly. Wait until the tool has reached its maximum
speed, Now you only have to push the tool forward
on the surface of the work piece, maintaining it flat
and advancing smoothly until the cutting process
has been completed.

4_MAINTENANCE INSTRUCTIONS

CLEANING, MAINTAINING, LUBRI-
CATING, SHARPENING.
Extract the battery before any manipulation of
the tool.
Maintain the tool and the grid clean in order to
work efficiently and safely.
Excessive dirtiness of the tool may cause it to work
deficiently.
Should the electric tool, despite the thorough
manufacturing and control processes, get
damaged, the repair must be entrusted to a
technical service authorized for Stayer tools.
For any question or request for spare parts it is
indispensable to state the model of the machine
that appears on the plate of characteristics on the
tool.

REPAIR SERVICE

The technical service will provide you advice
regarding questions you may have on the repair
and maintenance of your product as well as on
spare parts. You may also obtain exploded views
and information on spare parts on the internet
under: [email protected]
Our team of technical advisors will be glad to
guide you regarding acquisition, application and
adjustment of products and accessories.
GUARANTEE
Guarantee card Included in the documentation
that accompanies this equipment, you should
find the warranty card. You should fill out the
card completely and return to vendor with a copy
of purchasing receipt or invoice and you should
receive a receipt.
Note: If you cannot find the warranty card within
the documentation, you must ask for it through
your supplier.
The warranty is limited only to manufacturing
defects and expire if pieces have been removed
or manipulated or repaired other than the
manufacturer.
/ /
16