TerraTec AXON AX 50 Guía De Actualización Del Firmware página 5

Firmware Update Manual v2.0 Multilanguage
7. A prompt appears asking if you want to update the firmware in "SLOW Mode". Normally,
this is not necessary and you can just click "No". However, if you have problems with the
update, try it in SLOW Mode. In this transmission mode, the data are sent at a somewhat
slower rate. This applies only for the update on a PC.
8. A progress bar appears in the AXON display.
9. Wait until the loading process is finished. The following appears in the AXON display:
10. Wait until the erasing process is finished. The following now appears in the AXON
display:
11. Finally, the AXON is automatically restarted with the new firmware.
CAUTION: If this does not happen, you have to restart the AXON manually. However, be
absolutely certain to wait until the progress bar is complete, as otherwise the memory
module may not have been written correctly, which would result in total failure of the device.
You can safely restart approximately 30 seconds after all 16 segments of the progress bar
have been filled.
- 5 -