Philips HR6836/01 Manual De Instrucciones página 9

40
• To prevent overfilling and to protect the
motor, the round-shaped float shuts off the
air/water stream if the container is full
(fig. 40).
- If this happens, empty the container
(fig. 41). Then you can continue.
• Caution: When vacuuming water from a
basin which is higher than the appliance
(e.g. roof-gutter, cistern) the system will
inevitably function as a syphon.
As a result, the container may become
overfilled (fig. 42).
For your personal
safety, ensure
never to exceed
the maximum
capacity of the
container which
is 9 litre / 2 gallon
of water.
At regular intervals,
lift the nozzle out of
the water, switch off, remove the mains plug
from the wall socket and empty the
container.
After vacuuming liquid:
- Switch off. Remove the mains plug from the
wall socket. Empty, clean and dry the
container. Let the appliance operate with
dry clean air for a couple of minutes to dry
the inside of the tubes and hose.
41
42
MAX
9 Ltr.
Shampooing: floors
Remove: paper dustbag and Micro Filter.
Place: float unit, diffusor, (filled) shampoo
reservoir, Double Injection nozzle and
shampoo trigger.
- Prepare the vacuum cleaner as indicated
for "vacuuming liquid (water)" (i.e. previous
section).
43
- Fill the shampoo reservoir with cold water
(fig. 43).
- Add one measuring cap of the cleaning
liquid to the full reservoir (3 litre) (fig. 44).
45
- Place the shampoo reservoir (fig. 45).
- Attach the short shampoo tube to the
connector on the vacuum cleaner. Insert (1)
and rotate anti-clockwise (2) (fig. 46).
47
- Fix the shampoo trigger to the handgrip of
the hose (fig. 47, 48).
10
44
1x
46
2
1
48
3