Philips HR6836/01 Manual De Instrucciones página 10

49
- Firmly insert the end of the long shampoo
tube into the connector on the vacuum
cleaner ("Click!") (fig. 49).
To release: push the ring towards the
appliance (fig. 50).
51
- Attach the long shampoo tube to the flexible
suction hose and suction tubes using the
clips (fig. 51).
- Place the "Double Injection" nozzle (fig. 52).
The appliance is now ready for soft floors
(carpets, rugs).
53
- If you wish your nozzle close to hand (e.g.
for cleaning stairs, upholstery, tapestry) you
can connect the nozzle directly to the hose.
Fix the excess shampoo tube with a clip
(fig. 53).
- For hard floors (tiles, ceramic, stone,
synthetic) attach the "3-Actions" mopper to
the nozzle (fig. 54). Do not forget to secure
the mopper with the clip.
50
52
54
1
2
55
- Pull the mains plug out of the vacuum
cleaner and insert into the wall socket
(fig. 55).
- First switch on the pump (fig. 56) and then
57
the motor (fig. 57).
- Shampoo is applied by squeezing the
trigger at the tube handle (fig. 58).
- Start shampooing as far away from the door
as possible. From that point work your way
towards the door.
On completion of a lane, begin a new lane
with a slight overlap. In this way, the entire
area can be covered strip by strip.
If there are still traces of liquid on the
cleaned strip, these areas can be
vacuumed over again, but make sure that
the trigger control is released!
59
- After shampooing, release the trigger and
switch off the pump (fig. 59). Let the motor
run on.
Hold the nozzle high and let the appliance
operate with air only for some time to dry
the inside of suction hose and tubes
(fig. 60).
- Switch off the motor.
11
56
58
60