Heat Source Check; Electric Dryers; Gas Dryers; Electrical Requirements - Eudora T24 Guia De Instalacion

Heat Source Check

NOTE: This manual is only a supplement. Refer to
installation/operation manual for full instructions.

Electric Dryers

Close the loading door and start the dryer in a heat
setting (refer to Operation section). After the dryer has
operated for three minutes, the exhaust air or exhaust
pipe should be warm.

Gas Dryers

IMPORTANT: This operation is to be conducted
by qualified personnel only.
WARNING
To reduce the risk of serious injury or
death, the lower front panel must be in
place during normal operation.
© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
511472 (EN)

Electrical Requirements

NOTE: This manual is only a supplement. Refer to
installation/operation manual for full instructions.
Electric Dryers
Refer to serial plate for requirements.
SINGLE-PHASE MODELS
(230 Volt, 50 Hertz, 2 Wire Plus Earth, 30 Amp
Installation)
THREE-PHASE MODELS
(400/240 Volt, 50 Hertz, 4 Wire Plus Earth, 10 Amp
Installation)
NOTE: Refer to Kit 756P3 for Delta to Wye
conversion instructions.
W158
To reduce the risk of fire, electric shock,
severe personal injury or death, all wiring
and earthing MUST abide with local
electrical codes. It is the customer's
responsibility to have the wiring and
fuses checked by a qualified electrician to
make sure the laundry room has adequate
electrical power to operate the dryer.
Installation/Operation Supplement
WARNING
W458
9