Installing The Battery; Charging The Battery - Garmin GLO 2 GLONASS Manual De Instrucciones

GLO™ 2 GLONASS and
GPS Sensor Instructions

Installing the Battery

WARNING

This product contains a lithium-ion battery�
See page 5 for important battery safety
information�
1
With your thumbnail, slide the battery
cover release tab
➊
➋
2
Remove the battery cover
3
Locate the metal contacts on the end
of the lithium-ion battery�
4
Insert the battery
➌
contacts on the battery align with
the metal contacts inside the battery
compartment�
5
Press the battery down into place�
2
Glo_2_Instructions_print.indd 2
6
Replacement Battery
You can purchase a replacement battery
(010-11935-00) at http://buy�garmin�com�

Charging the Battery

You can use the sensor while you are
charging it�
�
1
2
➊
➌
It takes about three hours to charge the
battery� A fully charged battery lasts about
�
➋
13 hours�
NOTE: If the battery has not been charged
for a long period of time, remove the
so the metal
battery, connect the cable to the device
and a power source, and then replace the
battery� The battery will charge as usual�
Insert the battery cover into the
notches and press down�
The release tab locks the cover in
place�
Plug the small end of the power cable
into the mini-USB connector on the
end of the sensor�
Plug the other end of the power cable
into an appropriate source of power for
the cable type�
8/1/2018 12:36:52 PM