Tabla de contenido
Idiomas disponibles
Idiomas disponibles
GB
Troubleshooting
Problem
Possible cause
Solution
Pressure incorrect
Set the correct air pressure according to the specification
Dirt within the mechanism
Pour oil into air inlet as per maintenance instructions
Air blockage
Operate tool in short bursts to clear blockage
Tool operating slowly
Check all fittings and hose for air leaks and correct issue by re-tightening, using
Air leak
PTFE tape or replacing
Blockage in gauze mesh filter
Remove Quick Connector (3) and clean mesh filter
Dirt or rust in mechanism
Try 'Tool operating slowly' solutions
Tool seized
Dirt or rust in mechanism
Tap tool gently with a soft mallet
Dirt or rust in mechanism
Free mechanism by rotating drive manually when disconnected from air line
Tool will not stop after trigger is
Throttle valve O-ring or valve seat damaged
Have the tool repaired at an authorised Silverline service centre
fully released
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
8
Tabla de contenido
Solución de problemas
