Connecting The Remote Control Unit - Westen Boyler digit 240/40 Fi Manual Del Usuario

An external probe, supplied as an accessory, can be connected to the boiler.
For connections, see figure 16 and the instructions provided with the probe.
With the external probe connected, buttons +/- adjusting the heating circuit temperature (figure 1) regulates the coefficient of heat
dispersion (1...90). Charts 3 and 4 show the correspondence between the set value and the relative curves. Intermediate curves can also
be selected.
IMPORTANT:
the delivery temperature TM depends on parameter F16 (see section 21). Max. temperature, in fact, can be set at
85 or 45 °C.
Curve kt
Chart 3
Chart 4
TM = Delivery temperature
Te = External temperature

29. CONNECTING THE REMOTE CONTROL UNIT

(SUPPLIED AS AN ACCESSORY)
The remote control device is not a standard boiler component as it is supplied as an accessory.
Open the electronic board and connect the cable (supplied together with the two-pin terminal board) to connector Cn7 on the electronic
boiler board. Connect the terminals of the remote control device to the two-pin terminal board (figure 17).
CN 7
Figure 17
INSTRUCTIONS FOR FITTERS 926.008.2 - EN
53