Andis CNG-1 Instrucciones De Uso Y Cuidado página 7

FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you
know is working).
2. Check to make sure adapter cord plug is plugged firmly into bottom of nail
grinder. If failure to charge still exists, return nail grinder to Andis or an Andis
authorized service station for examination and repair or replacement.
CORDLESS OPERATION
When the battery is fully charged, the green FULL BATTERY light will blink. When the
battery charge is low, the green FULL BATTERY light will turn off and the red CHARGE
BATTERY light will blink (Figure G).
Once the battery has fully run down (after approximately 180 minutes of use), the
red CHARGE BATTERY light will turn off, indicating that the battery should be
recharged or the nail grinder should be used with the adapter cord (Figure G).
USE WITH ADAPTER CORD
If the nail grinder powers off in the middle of a job, the adapter cord can be attached
to continue use in corded operation. When the unit is running with the adapter cord
attached, the green FULL BATTERY light will remain on and the red CHARGE BATTERY
light will blink (Figure G).
USING THE GRINDER ATTACHMENTS
Your Andis nail grinder comes with a conical grinding stone, a grinding wheel and
a multi-function protective cap (Figure G). It is recommended to use only Andis
attachments made specifically for the CNG-1 nail grinder.
The multi-function protective cap has three ports, suitable for use on small or large
size pets (Figure H). The multi-function protective cap should only be used with
the grinding wheel.
• Use Port "A" for small sized pets.
• Use Port "B" for large sized pets.
• Use Port "C" for quick nail grinding. Use your thumb and index finger to hold your
pet's paw, and touch the grinder slightly to start grinding the nail. Do not keep the
grinding stone against the nail for longer than three seconds at a time. (Figure H).
To remove multi-function protective cover: Twist counterclockwise to unlock and
pull straight up (Figure I).
To remove grinding wheel: Grip the grinding wheel and pull straight up.
To insert a new grinding wheel: Insert new grinding wheel into slot and push down
firmly.
IMPORTANT: Before each use, check that the grinding stone or wheel is secure. If
loose during operation, attachment may be ejected from nail grinder and cause
injury.
7