Power Supply - Andis CNG-1 Instrucciones De Uso Y Cuidado

POWER SUPPLY

This unit is equipped with a universal AC/DC power adapter/battery charger (Figure A).
1. Remove the power adapter and charger from the carton.
2. Note the charger comes standard with a universal AC voltage power adapter and
three interchangeable plugs (Figures A-D).
3. To attach the desired plug to the power adapter, place the tabs on the plug inside
the slots on the power adapter and slide plug down until it "clicks" into place. To
remove, press the semi-circular button on the power adapter and slide the plug
off. The plugs for the various countries all attach and remove using the same
method (Figures E & F).
4. Connect the power cord to the back of the nail grinder and then insert the power
adapter into an AC outlet.
CHARGING NAIL GRINDER
The battery charger is intended for use with Andis CNG-1 nail grinder. Remove the
nail grinder and charger from the carton. Plug the charger into a 230V AC outlet.
The nail grinder must be OFF before plugging the charger into the outlet. Plug the
adapter cord plug directly into the bottom of the nail grinder (Figure G). The nail
grinder has a lithium-ion battery that cannot be damaged by overcharging. We
recommend that the nail grinder be unplugged if not used for seven or more days.
NAIL GRINDER INDICATOR LIGHTS
See the chart for charging status and corresponding indicator lights.
Nail Grinder in Use
Full Charge
Low Charge
Turbo Speed
Nail Grinder Charging
When Charging
Fully Charged
6
NAIL GRINDER INDICATOR LIGHT STATUS
Indicator Light Status
FULL BATTERY light blinks
CHARGE BATTERY light blinks
TURBO light on (RED)
Indicator Light Status
CHARGE BATTERY light on
FULL BATTERY light blinks
CHARGE BATTERY light off
FULL BATTERY light on