Instructions For Use - Campingaz PARTY GRILL Instrucciones De Empleo

INSTRucTIONS fOR uSE

NOTE: Unless otherwise specified, following generic terms
"appliance / unit / product / equipment / device" appeared
in this instruction manual all refer to the product "PARTY
GRILL".
Consumption: 98 g/h (1.35 kW) - injector no. 015556
Category: direct butane pressure.
Thank you for having chosen this Campingaz
A - IMPORTANT: YOU ARE USING GAS, TAKE
GREAT CARE !
These instructions are intended to help you to operate
your Campingaz Party Grill.
®
Read them carefully to familiarise yourself with the
equipment before connecting it to the cartridge.
follow these instructions for use as well as the
safety instructions on the CV 470 Plus/ CV 270 Plus/
cV300 Plus campingaz cartridges. failure to follow
®
these instructions may endanger the safety of the
user and any other persons in the vicinity.
Keep these instructions in a safe place so that you
can refer to them if necessary.
This equipment should
campingaz cV 470 Plus/ cV 270 Plus/ cV300 Plus
®
cartridges. It may be dangerous to use other gas
cylinders.
The Application des Gaz Company declines all
responsibility if another brand of cartridge is used.
This equipment must be used only in areas that are
properly ventilated (minimum 2 m
from inflammable material.
Do not use an appliance which is leaking, not
operating correctly or worn. Take it to your retailer
who will give you details of your nearest After Sales
Service.
Never modify the equipment or use it for any purpose
for which it is not intended.
Do not use this product in caravans, cars, tents,
huts, sheds or any small enclosed areas.
The product should not be used while sleeping or
left unattended.
This product consumes fuel through combustion
or consumption of oxygen and gives off certain
substances and gas, which could be dangerous
such as carbon monoxide (CO).
Carbon monoxide is an odorless, clear gas that
can cause flu-like symptoms, sickness, illness,
and possibly death if produced inside aforesaid
enclosed areas through use of the product without
proper ventilation.
B - ASSEMBLING
PARTY GRILL STOVE
a) Remove the stove from its packing, remove the lid (2), the
hot-plate (3) and the pan supports : cross-pieces (4) (fig.
2)
b) Remove the legs (8) turn the stove upside down and fit
them into the slots; push the legs until they click into place
(fig. 4)
c) Make sure that the water reservoir (5) is connected
correctly. Turn the reservoir until it arrives at the arrow "v"
(fig. 3).
Party Grill.
®
be used only with
/h/kw) and away
3
YOUR CAMPINGAZ
®
5
d) Ensure that the burner (6) is mounted correctly (fig. 3)
e) Place the stove on a firm, horizontal surface. For use in
other circumstances, see paragraph H.
c- fITTING A cAMPINGAz
270 PLuS/ cV300
PLuS
(If there is already an empty cartridge, read paragraph G,
"Removing the cartridge").
To fit or remove a cartridge, always work in a well
ventilated area, preferably outdoors, away from other
people and inflammable material, never near a naked
flame, heat or spark source (cigarettes, electrical
equipment, etc).
AS CAMPINGAZ CV 470 PLUS/ CV 270 PLUS/
®
CV300 PLUS CARTRIDGES HAVE VALVES, EVEN IF
THEY ARE NOT EMPTY, THEY MAY BE REMOVED
FROM THIS EqUIPMENT TO MAkE IT EASIER TO
TRANSPORT, AND THEY MAY BE FITTED TO OTHER
EqUIPMENT FROM THE CAMPINGAZ
PLUS / CV 270 PLUS/ CV 300 PLUS RANGE WHICH
ARE DESIGNED TO OPERATE EXCLUSIVELY WITH
THESE CARTRIDGES.
a) Ensure that the gas inlet is in the closed position turn the
knob (7) clockwise to the arrow(-).
b) Turn the appliance upside down.
c) (Fig. 6) Gently screw in the gas cartridge by turning it
clockwise until you hear a click (approximately one-sixth
of a turn). Do not force the cartridge to turn further than
this; you will risk damaging the cartridge valve.
If there is a gas leak (you can smell gas before opening
the tap) immediately take the unit outside, to a very
well ventilated place which is free of sources of gas
ignition, where the leak might be located and stopped.
If you want to test for leaks, do so outside. Do not test for
leaks with a flame, but use gas leak solution.
D - PREPARING THE PARTY GRILL FOR USE AS
A "HOT-PLATE"
a) Fill the reservoir with 3/4 of a litre of water (5). The
level should be a few milimetres under the central tube:
(fig. 3) mark "n"
b) Place the hot-plate (3) onto the support according to the
index marks (4).
E - USING THE PARTY GRILL AS A "HOT-PLATE"
(FIG. 8/a)
a) Lighting the burner
1) Open the tap by turning it (fig. 7) anti-clockwise: 1
rotation maximum.
2) Press the button (fig. 7) with the thumb until the piezo
system operates. This is made easy if the other fingers
are placed in the slot provided. (fig. 7)
3) If the burner flame is not visible under the hot-plate,
(fig. 7), recommence the procedure "b".
4) After 3 attempts, close the tap by turning it clockwise as
far as it will go. Check that the cartridge contains gas
and start the lighting operations a) and b) again.
b) Pre-heating
Pre-heat the hot-plate for one minute at maximum in order
to reach the ideal temperature for cooking.
cV 470 PLuS/ cV
®
cARTRIDGE
CV 470
®
GB