Instructions For Use; For Your Safety; Checking For Gas Leaks; Prior To Use - Campingaz ATTITUDE 2go Instrucciones De Empleo

NOTE: Unless otherwise specified, the following generic terms "appliance / unit / product / equipment / device" stated in this
instruction manual, all refer to the product "Attitude 2go".
The product shown in this manual may look different from yours. It is for illustration purpose only.
y Please read the instructions carefully before use.
y Use outdoors only.
y It is best to wear gloves to assemble the product.
y Do not use charcoal on this product.
y Do not use an adjustable low pressure regulator. Only use fixed regulators that comply with relevant
European Standards.
y Non respect of these instructions may be dangerous for the user and anyone else close by.
y To ensure safe operation of your device, never use two full griddles side by side.
y Regularly clean the parts at the base of the fire box to avoid risk of inflammation from excess grease.
Follow these instructions carefully to avoid serious damage to your barbecue.
This product is designed for a normal private use, not intended for commercial purposes
A. FOR YOUR SAFETY
y Do not store or use petrol and other flammable liquids or
vapours in the vicinity of this appliance. This device must
be kept away from inflammable materials when it is in use.
If you smell gas:
1. Close the valve of the gas bottle.
2. Extinguish all naked flames.
3. Open the lid.
4. If the smell continues, see "F. Checking for gas leaks" or
immediately seek advice from your local retailer.
y Do not leave your appliance unattended while it is in
operation.
y Parts which are protected by the manufacturer or the
manufacturer's representative must not be manipulated by
the user.
y Seal the gas bottle after use.
GB
B. LOCATION
y This appliance must only be used outdoors.
y CAUTION: accessible parts may get very hot. Keep children
away.
y There should be no combustible materials within a radius of
approximately 60 cm around the appliance.
y Do not move the appliance when alight.
y The appliance should be operated on a level surface.
y Estimated air offtake is 2 m
C. GAS BOTTLE
This appliance has been adjusted to operate from 3 to
15 kg butane/propane gas bottles with an appropriate low
pressure regulator:
y France,
Belgium,
kingdom, Ireland, Portugal, Spain, Italy, Greece:
butane 28 mbar / propane 37 mbar.
y Netherlands, Czech Republic, Slovakia, Hungary,
Switzerland, Slovenia, Norway, Sweden, Denmark,
Finland, Bulgaria, Turkey, Romania, Croatia, Latvia,
Estonia, Lithuania:
butane 30 mbar / propane 30 mbar.
y Poland: propane 37 mbar.
Always connect or replace the gas bottle in a well-ventilated
area, never in the presence of a flame, spark or heat source.
D. HOSE (FIG 1-2 & 3)
The appliance should be used with flexible hose that is suitable
for use with butane and propane gas. Hose length should not
exceed 1.50 metre. It should be replaced if it is damaged or

INSTRUCTIONS FOR USE

/kW/h.
3
Luxembourg, Cyprus,
cracked, when required by national regulations or at the end
of its lifecycle.
France (depending on model):
Flexible hose designed to be joined onto ringed tail pieces on
both the appliance and regulator sides, held firm with collars
(in accordance with standard XPD 36-110). Recommended
length 1.25 m.
1. Connect the flexible hose to the connector and secure the
connection with a clamping collar (Fig 2).
2. Connect the other end of the hose to your regulator and
secure the connection with a clamping collar (Fig 2).
3. Connect the regulator to your cylinder (Fig 2).
4. Check for leaks following the instructions in section F.
Do not pull or pierce the hose. Keep away from any parts of the
appliance that get hot. Check that the flexible hose stretches
out normally, without twisting or pulling. (Fig. 3A & 3B)
E. LID
Handle the lid carefully, especially when the grill is on. Do not
lean over the fire box or cooking surface as this area can get
very hot.
F. CHECkING FOR GAS LEAkS
Important: never use a naked flame to check for gas leaks.
1. Work outside, away from all sources of ignition.
Do not smoke.
2. Make sure the control knobs are in the "OFF" (O) position.
3. Fit the regulator onto the gas bottle in accordance with its
instructions.
4. Connect the flexible hose to the regulator and appliance as
described in section D.
5. Use a gas leak solution to test for leaks.
6. Apply the solution to the connections between gas bottle/
United
regulator/ hose / appliance. (Fig 4)
7. Open the gas bottle valve (The control knob should remain
in the "OFF" (O) position). Bubbles in the gas leak solution
indicate if there is a gas leak.
8. To fix the leak, tighten the regulator nut on the gas cylinder.
9. The grill must not be used until all leaks have been
eliminated.
10. Close the valve on the gas bottle.
11. Unplug the regulator from the gas bottle and contact your
local after-sales service centre for assistance.
Important:
Check for leaks at least once per year and each time the gas
cylinder is replaced.
G. PRIOR TO USE
Never use the appliance until the instructions have been read
8