CP FAS 3000 Manual De Instrucciones página 4

Part no 2050479093
Issue no 02
Series no -
Date 12/2006
Page 4 / 59
ACCESSORY
PT No. Description
396843 Mains power cable (UK)
396853 Mains power cable (European)
459323 Mains power cable (USA)
REMOTE INTERFACE
There are 3 sockets on the sides of the unit that can be used to interface with the FAS3000 remotely or communicate
with other equipment.
ie. Solenoid, Remote Control Box, PC. etc.
RS232 Connector for software interface (Due 2003).
Recommended interface cable type: Shielded cable.
15 PIN SOCKET
Pin Function
Pin 1 Power out (+24V DC)
Pin 2 Reset for cycle NOK
Pin 3 Reset for group
Pin 4 Screw OK
Pin 5 Screw NOK
Pin 6 Group OK
Pin 7 Group timer Start
Pin 8 7 pin socket, pin 5
Pin 9 Ground
Pin 10
Pin 11 See table on right
Pin 13
Pin 12 Solenoid Valve
Pin 14 Not used
Pin 15 7 pin socket, pin 7
* see FAS 3000 Flow Chart
Input/Output Mode
Output Always +24V DC. Should only be used to power coupled
inputs of the microprocessor module.
Input +24V DC to reset
Input +24V DC to reset
Output +24V DC - remains on until next cycle starts
Output +24V DC - remains on until either the NOK cycle or group
reset is enabled
Output +24V DC - remains on until next group starts
Input +24V DC to enable group Timer. Must be disabled and
enabled before every Group operation (minimum interval
100ms)
- -
- Always 0V DC
A
0V
Input 0V
0V
Output +24V DC when the key with the solenoid logo is switched to
on and a cycle NOK has occurred.
- -
- -
FAS 3000
Selecting parameter sets*
B C D E
0V 0V 0V 24V
0V 24V 24V 0V
24V 0V 24V 0V
F G H
24V 24V 24V
0V 24V 24V
24V 0V 24V