Checklist; Before Starting - Sears Craftsman 580.752340 Instrucciones De Uso

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Connect
Hose and Water
Supply
to Pump
IMPORTANT:
To avoid pump damage, you must
assemble the nozzle extension to the spray gun and
attach all hoses before you start the engine.
1.
Uncoil high pressure hose and attach one end of
hose to base of spray gun. Tighten by hand.
2.
Remove and discard shipping caps from pump
inlet and outlet.
3.
Attach other end of high pressure hose to high
pressure outlet on pump. Tighten by hand.
.
Before connecting garden hose to water inlet,
inspect inlet screen. Clean screen if it contains
debris or have it replaced if damaged. Refer to
section "O-Ring Maintenance" if inlet screen is
damaged. DO NOT run pressure
washer if inlet
screen Bsdamaged.
"_"---,....,__
inspect inlet
screen. DO
NOT use if
damaged;
clean if dirty.
5.
Run water through garden hose for 30 seconds to
flush it of debris. Turn off water.
IMPORTANT:
DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
6.
Connect garden hose (not to exceed 50 feet in
length) to water inlet. Tighten by hand.
CAUTION
* Damage
to equipment
resulting
from failure
to follow
this instruction
will void warranty.
7.
Turn ON water, point gun in a safe direction and
squeeze trigger to purge pump system of air and
impurities.
WARNING
Always
wear
safety
goggles
when
using this equipment
or in vicinity
of where
equipment
is in use.
Before
starting
the pressure
washer,
be sure you are
wearing
adequate
safety
goggles.
CHECKLIST
BEFORE
STARTING
Review the assembly to ensure you have performed
all of the following:
1.
Check that oil has been added to proper level in
engine crankcase.
2.
Add proper fuel to fuel tank.
3.
Check for properly tightened hose connections
(high pressure and water supply) and for tight
connections and that there are no kinks, cuts, or
damage to the high pressure hose.
4.
Provide proper water supply (not to exceed
100°F).
5.
Be sure to read "Safety Rules" and "Operation"
sections before using the pressure washer.
6.
If starting unit after storage, see "Storage" section
on pages 20o21.
Tabla de contenido
loading

Tabla de contenido