Sears Craftsman 580.752340 Instrucciones De Uso página 7

3. Placeaccessory t rayoverholesonhandle
(viewing fromfrontof unit).Pushtreeclipsinto
holesuntiltheysitflatagainst a ccessory t ray.
.
insert multi-colored ProjectPro
TM
nozzles and
other supplied accessories in spaces provided in
accessory tray. See "How to Use Accessory Tray".
Add Engine Oi_
CAUTmON! Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
1. Place pressure washer on a level surface.
2. Clean area around oil fill and remove oil dipstick.
3. Using oil funnel (optional), slowly pour entire
contents of provided oil bottle (18 oz.) into oil fill
opening.
4. Replace oil dipstick and fully tighten.
NOTE: See the section "Oil" on page 17 to review oil
recommendations.
Add Fuem
NOTE: This gasoline engine is certified to operate on
gasoline. Exhaust Emission Control System: EM
(Engine Modifications).
WARNING
WHEN ADDING FUEL
Turn pressure washer OFF and let it cool at least 2
minutes before
removing
fuel cap. Loosen cap
slowly
to
relieve pressure in tank.
Fill or drain fue! tank outdoors.
DO NOT overfill tank. Allow space for fuel
expansion.
Keep
fue! away from
sparks, open flames, pilot lights,
heat,
and other
ignition sources.
DO NOT
light a
cigarette or smoke.
Use clean, fresh, regular UNLEADED fuel with a
minimum of 85 octane with equipment. DO NOT
use fuel which contains Methanol. DO NOT mix oil
with fuel.
2. Clean area around fuel fill cap, remove cap.
3. Slowly add regular unleaded fuel to fuel tank. Be
careful not to overfill. Allow at least 1.5" of tank
space for fuel expansion, as shown here.
Lo Fuel
4. Install fuel cap and wipe up any spilled fuel.
CAUTION! Alcohol-blended fuels (called gasohol,
ethanol or methanol) can attract moisture, which leads
to separation and formation of acids during storage.
Acidic gas can damage the fuel system of an engine
while in storage.
To avoid engine problems, the fuel system should be
emptied before storage of 30 days or longer. Drain the
fuel tank, start the engine and let it run until the fuel lines
and carburetor are empty. Use fresh fuel next season.
See "Storage" on pages 20-21 for additional information.
NEVER use engine or carburetor cleaner products in
the fuel tank as permanent damage may occur.