Sears Craftsman 580.752340 Instrucciones De Uso página 6

Yourpressure washer requires s omeassembly a ndis
readyforuseonlyafterit hasbeenproperly serviced
withtherecommended oil andfuel.
If you haveanyproblemswith the
assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
REMOVE PRESSURE WASHER
FROM CARTON
• Slice two corners of carton from top to bottom so
the panel can be folded down flat.
• Remove fillers, accessories and parts bag shipped
with your pressure washer.
• Roll pressure washer out open end of carton.
• Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
• The main unit
Handle
Accessory tray
Spray gun
High pressure hose
Nozzle extension with quick connect fitting
Engine oil
Parts bag (which includes items listed below)
• Operator's manual
• Registration card
• Turbo nozzle
• Bag containing 4 multi-colored ProjectPro
TM
nozzles
• Handle fastening hardware kit (which includes):
• Carriage bolt (2)
• Plastic knobs (2)
• Tree clips (4)
Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration on page 5. If any parts are missing or
damaged, call the pressure washer helpline at
1.800o222o3136.
ASSEMBUNG YOUR PRESSURE
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1. Fill out and send in registration card.
2. Attach handle.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Select/attach quick connect nozzle to nozzle
extension.
Attach Handle
1. Place handle onto handle supports connected to
main unit. Make sure holes in handle align with
holes on handle supports.
Holes _ _:_//>
Align -"'_/ i_ 4
/i Handle /
/ / Supports /
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert carriage bolts through holes from outside of
unit and attach a plastic knob from inside of unit.
Tighten by hand.