General Information; Purpose Of The Document; Using This Document; Intended Use - Webasto Next Manual Del Usuario

EN

General information

1

Purpose of the document

1.1
This Quick Start Guide forms part of the product and con-
tains introductory information as well as information re-
lated to safety and the installation of the Webasto Next
product. The comprehensive Installation Manual available
under the QR code supplied is required for safe operation
of your Webasto Next and for safe installation by an elec-
trician.
1.2

Using this document

u Carefully read this Quick Start Guide prior to installing
and starting up the Webasto Next.
u Keep these instructions ready to hand.
Hand this document on to the following owner or
u
user of the charging station.
NOTE
We would draw your attention to the fact that, as
part of a professional installation, an installation log
should be drawn up by the installer. We also request
that you fill in our Check list for the installation of the
Webasto charging station.
NOTE
Individuals with deficiency in their colour vision re-
quire support in the allocation of all fault indicators.
1.3

Intended use

The Webasto Next charging station is designed for char-
ging electric vehicles in accordance with IEC 61851-1,
charge mode 3.
1.4

Use of symbols and highlighting

DANGER
This signal word denotes a hazard with a high degree
of risk which, if not avoided, may lead to death or ser-
ious injury.
WARNING
This signal word denotes a hazard with a moderate
degree of risk which, if not avoided, may lead to
minor or moderate injury.
12
CAUTION
This signal word denotes a hazard with a low degree
of risk which, if not avoided, will lead to minor or
moderate injury.
NOTE
This signal word denotes a Special Technical Feature
or (if not observed) potential damage to the product.

Warranty and liability

1.5
Webasto shall not accept liability for defects or damage
due to the failure to comply with the installation instruc-
tions.
2

Safety

2.1 General information
The device must only be used in a technically faultless
condition.
Any malfunctions that adversely affect the safety of per-
sons or of the device must be immediately rectified by a
qualified electrician in accordance with nationally applic-
able regulations.
NOTE
It is possible that the signalling in the vehicle differs
from that described here. Always read the operating
instructions of the respective vehicle manufacturer
and always observe these.

General safety information

2.2
– Hazardous voltages are present within the casing.
– The charging station does not have its own main
ON/OFF switch. The protective devices installed in
the power supply system are therefore also used
to disconnect the power supply.
– Check charging station for visual damage before
use. Do not use the charging station if damaged.
– Installation, electrical connection and initial opera-
tion of the charging station must only be carried
out by an electrician.
– Do not remove the cover of the installation area
whilst in operation.
– Do not remove markings, warning symbols and
the type label from the charging station.
– The charging cable must only be replaced by an
electrician in accordance with the installation in-
structions.
– It is strictly prohibited to connect other equip-
ment/devices to the charging station.
– Make sure that the charging cable and coupling
cannot be driven over, trapped and are protected
from any other hazards.
– Immediately notify Webasto Customer Service if
the charging station, charging cable or the char-
ging coupling are damaged. Do not continue us-
ing the charging station.
– Prevent the charging cable and coupling from
coming in contact with external heat sources, wa-
ter, dirt and chemicals.
– The Webasto Next charging station also meters
the plug-in cycles of the charge coupling for ser-
vice purposes and after 10,000 plug-in cycles, dis-
plays a note on the web interface that an electri-
cian needs to inspect the plug contacts on the
charge coupling for any signs of wear. If any signs
of wear are discovered, the electrician must re-
place the affected charging cables with genuine
Webasto spare parts.
– Do not attach extension cables or adapters to the
charging cable.
– Remove the charging cable by pulling on the char-
ging coupling only.
– Never clean the charging station with a high-pres-
sure cleaner or similar device.
– Switch off the power supply before cleaning the
charging sockets.
– The charging cable must not be subjected to any
strain during use.
– Ensure only persons who have read these operat-
ing instructions have access to the charging sta-
tion.
WARNING
5111233A_ISI_Next